Gordy29

Forum Replies Created

Viewing 15 posts - 31 through 45 (of 53 total)
1 2 3 4
  • Author
    Posts
  • May 20, 2009 at 7:28 pm in reply to: Beko Drvs 62w tumble dryer #287475
    Gordy29
    Participant

    Re: Beko Drvs 62w tumble dryer

    thanks Galway,but the heater gets hot

    March 26, 2009 at 6:31 pm in reply to: bosch sgs55c02gb/01 #281396
    Gordy29
    Participant

    Re: bosch sgs55c02gb/01

    thank’s gegsy gordy

    May 29, 2008 at 5:46 pm in reply to: wf720p stuck on test on dispay #253250
    Gordy29
    Participant

    Re: wf720p stuck on test on dispay

    thank youwill try it tomorrow in customers tomorrow.gordy29

    February 3, 2008 at 12:17 pm in reply to: Bosch classixx 1200 express #242020
    Gordy29
    Participant

    Re: Bosch classixx 1200 express

    check the end of the filter . i,ve had apenny stuck in the end hole which will stop drain cycle

    November 27, 2007 at 6:07 pm in reply to: zanussi fx1265 w/machine #235430
    Gordy29
    Participant

    Re: zanussi fx1265 w/machine

    thanks hello 75 it flashes once ,sorry about the delay in reply.gordy29
    ,

    October 13, 2007 at 6:00 pm in reply to: BEKO WASHER #230697
    Gordy29
    Participant

    Re: BEKO WASHER

    you will not get this out properley. to avoid this getting worse, run the machine on a maintenance wash. 60 wash on weekly or two weekly intervals use a good powder run empty of clothes. Also leave the door open on machine. To read more go to the self help and advice section on this web site. hope that helps . gordy

    October 9, 2007 at 6:21 pm in reply to: Hotpoint WMA36 Overfilling #230304
    Gordy29
    Participant

    Re: Hotpoint WMA36 Overfilling

    try the pressure hose .the one i had itook the hose off then saw a rubbed part .but could not feel it in situ.

    October 9, 2007 at 5:57 pm in reply to: Hotpoint deluxe 7842 #230284
    Gordy29
    Participant

    Re: Hotpoint deluxe 7842

    i had one of these recently motor capacitor u/s 7or 8 microfarads

    October 8, 2007 at 7:04 pm in reply to: TYPICAL MONDAY #230175
    Gordy29
    Participant

    Re: TYPICAL MONDAY

    after 30 years in the trade every day is starting to feel like monday.the rubbish well named makers churn out is appalling.apartfrom that i,ve had good day.

    October 6, 2007 at 10:55 am in reply to: hotpoint wf240 #229788
    Gordy29
    Participant

    Re: hotpoint wf240

    🙂 thanks jim i will try that gordy

    September 10, 2007 at 7:38 pm in reply to: Bosch WFO2855GB/01 no spin. #226560
    Gordy29
    Participant

    Re: Bosch WFO2855GB/01 no spin.

    i,ve had this fault run the machine on a 40c wash empty.

    September 10, 2007 at 7:21 pm in reply to: bosch dishwasher sgs5302gb/07 #227156
    Gordy29
    Participant

    Re: bosch dishwasher sgs5302gb/07

    thank you chris,agreat help Gordy

    September 10, 2007 at 4:46 pm in reply to: bosch dishwasher sgs5302gb/07 #227154
    Gordy29
    Participant

    Re: bosch dishwasher sgs5302gb/07

    sorry about not getting back to you Martin , pressure system ok it even runs the pumpwith micro switch unplugged ,thanks

    September 5, 2007 at 6:20 pm in reply to: zanussi TC482W #226734
    Gordy29
    Participant

    Re: zanussi TC482W

    i had the same prob with one of these,s a large bit off fluff had balled up then jammed the tub.moving the tub back and fro pulled out fluff with coathanger

    September 1, 2007 at 5:33 pm in reply to: Fan oven doesn’t heat, but element is OK #226336
    Gordy29
    Participant

    Re: Fan oven doesn’t heat, but element is OK

    the stat light is the neon whtch tells you when temperature is attained ,then go,s out.

  • Author
    Posts
Viewing 15 posts - 31 through 45 (of 53 total)
1 2 3 4