jay651

Forum Replies Created

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • in reply to: Hotpoint WMA63 Ultima #296469
    jay651
    Participant

    Re: Hotpoint WMA63 Ultima

    Cheers thanks for that

    in reply to: Hotpoint RZ150P freezer #295860
    jay651
    Participant

    Re: Hotpoint RZ150P freezer

    Thanks for that,have sent a email to Hotpoint,but doubt if will do any good

    in reply to: Whirlpool arc1738 tall fridge #180699
    jay651
    Participant

    Re: Whirlpool arc1738 tall fridge

    All sorted,getting a Hotpoint as a replacement,speaking with Whirlpool this morning,they say door cannot be reversed.

    in reply to: Whirlpool arc1738 tall fridge #180697
    jay651
    Participant

    Re: Whirlpool arc1738 tall fridge

    Hi
    Thanks ,just rang Whirlpool,there not sure so going to get back to me. If the door handle can be unscrewed and put on the other side does that mean I have to make 2 new holes in the door as there is no place that it can be mounted at the moment

    in reply to: Whirlpool arc1738 tall fridge #180695
    jay651
    Participant

    Re: Whirlpool arc1738 tall fridge

    Hi
    Thanks for that, in the instruction book there is a note saying -The direction of the door can be changed.If this operation is performed by After sales service it is not covered by the warranty. I still cannot see how it can be changed from the handle point of view.Think I will give Whirlpool a ring tomorrow. On the Currys site it does say reversible doors and thats one of the reasons I bought this particular model

    in reply to: Hotpoint RLA 80 Larder Fridge #124675
    jay651
    Participant

    Re: Hotpoint RLA 80 Larder Fridge

    Hi Dave
    Thanks for the advice,don’t know the answers to the questions you have just posed,but will try and find out and will get back to you.
    Cheers for now
    John

    in reply to: Hotpoint RLA 80 Larder Fridge #124673
    jay651
    Participant

    Re: Hotpoint RLA 80 Larder Fridge

    The tray is about half an inch from the motor,the engineer did try and make it kind of level (very flimsy so hard to do) and I will remove over half a litre of water every ten days,and if not will overlow

    in reply to: Hotpoint RLA 80 Larder Fridge #124671
    jay651
    Participant

    Re: Hotpoint RLA 80 Larder Fridge

    Thanks for quick reply,normal stuff in fridge.I think the water is supposed to evaporate away as the tray is on top of the motor,thats where the problem is,it does’nt go away and eventually just builds up then overflows.As i said in the last post the flooring was warping underneath,if is was lino I probably would’nt have noticed.If it was wood it would eventually rot away and the fridge would disappear down a big hole.(where I think its heading for If I dont find a cure0

Viewing 8 posts - 1 through 8 (of 8 total)