UK Whitegoods

Forum Replies Created

Viewing 15 posts - 1 through 15 (of 57 total)

1 2 3 4 →

Author

Posts
December 21, 2022 at 12:17 pm in reply to: Rangemaster professional plus 110 induction 13 yrs old range cooker #484970

JENKS
Participant

Hi Dave
This is the earlier older version that has multiple boards and i dont believe that it need configuring.
I have fitted the larger board to a rangemaster in the past and configured it but this one is different.
It has the boards that i listed in my original enquirey thanks.
Paul

December 21, 2022 at 9:04 am in reply to: bosch induction hob error e1 #451074

JENKS
Participant

no sorry hope you sorted this

January 16, 2019 at 2:28 pm in reply to: Hotpoint freezer FZS175P Replaced main board but not illuminating #459983

JENKS
Participant

jenkinsjohn005@gmail.com

January 16, 2019 at 12:26 pm in reply to: Hotpoint freezer FZS175P Replaced main board but not illuminating #459981

JENKS
Participant

Hi service book and wiring diagram would be appreciated.
thanks
paul

January 16, 2019 at 12:17 pm in reply to: Hotpoint freezer FZS175P Replaced main board but not illuminating #459980

JENKS
Participant

After installing new board, compressor starts runs for approx 30 seconds then stops, no illumination from board at all.

January 16, 2019 at 8:59 am in reply to: Hotpoint freezer FZS175P Replaced main board but not illuminating #459978

JENKS
Participant

Hi Dave.
I ordered a programmed board both times.
Paul

December 8, 2016 at 4:42 pm in reply to: Smeg induction hob error codes #443428

JENKS
Participant

Re: Smeg induction hob error codes

MODEL NUMBER SY92IPX8

May 26, 2016 at 7:46 am in reply to: miele t8320 wont dry on sensor dry #437925

JENKS
Participant

Re: miele t8320 wont dry on sensor dry

yes dave tried it with wet clothes in,runs for approx 2 mins then stops

May 23, 2016 at 8:32 pm in reply to: samsung wf80f5e5u4w/eu error 3e #437823

JENKS
Participant

Re: samsung wf80f5e5u4w/eu error 3e

Has motor not direct drive,I was unaware samsung did a direct drive

April 21, 2016 at 3:34 pm in reply to: miele dryer t8302 starts then stops after 1 min #437219

JENKS
Participant

Re: miele dryer t8302 starts then stops after 1 min

brushes look fine ,plenty of wear left in them

April 18, 2016 at 7:12 am in reply to: Domestic appliance repairer/installer required in lincs #436987

JENKS
Participant

Re: Domestic appliance repairer/installer required in lincs

sleaford area

December 8, 2015 at 8:13 pm in reply to: hotpoint ff4dk(uk) fridge freezer wire in door #433465

JENKS
Participant

Re: hotpoint ff4dk(uk) fridge freezer wire in door

Ok thanks for reply will tell my customer to get in touch with hotpoint

April 14, 2015 at 4:43 pm in reply to: Hoover vhv680c no heat #426475

JENKS
Participant

Re: Hoover vhv680c no heat

Tried on refresh program,which I presume is cold cycle,still same,after 20 seconds all lights flash

April 13, 2015 at 6:36 am in reply to: Hoover vhv680c no heat #426474

JENKS
Participant

Re: Hoover vhv680c no heat

It doesn’t have a cold setting

April 12, 2015 at 7:28 pm in reply to: Hoover vhv680c no heat #426472

JENKS
Participant

Re: Hoover vhv680c no heat

Yes if low heat selected same
Author

Posts

Viewing 15 posts - 1 through 15 (of 57 total)

1 2 3 4 →