[johnbb]

Re: Belling Dual fuel top oven

Thanks Phil, Just to set your mind at ease, power off was the first thing i did 😀 .
The handbood mentions two methods of heating top over – a grill element which is visible and one under the floor of the oven.
Ive loosened the back off and can see the two pairs of connections for the top grill element and one for the lower fan oven. but nothing for anything between the top of the lower oven and the bottom of the upper oven.
In fact the inner panel under the insulation seems to be continous from top to bottom apart from some 20mm dia holes running across the back about where the element should be.
Any ideas?

Regards

John

[johnbb]

Re: indesit D63

Hi Penguin, thanks for being so prompt, yes it’s been three months and we’re still washing up by hand…. in this day and age!
Actually she was never too happy with how the machine worked anyway, but I’m not sure if we were using it right, I had read the comments on the site about salt etc but the cups, plates etc always felt if they had grit stuck to them even after we’d cleaned the machine and kept sale levels up.
Anyway I have mailed the spares address you gave me and may be back for more advice.

regards

John

[johnbb]

Re: indesit D63

sorry, have just realised that I’d received another answer from Penguin, and not said thanks, so…….
Thanks!!
Is it an easy job to change the pcb? and are they expensive, I guess i’m going to find out one way or another lol
regards

John

[johnbb]

Re: indisit D63

thanks penguin but have checked those, it had just stopped working so all i can think of is a control fault of some kind?

Regards

John

[johnbb]

Re: indesit g74c tumble dryer

Many thanks to both Jim and Penguin45 for your help, lets hope i’m not back next week with another question

Regards to both

John

[johnbb]

Hi many thanks for your prompt reply, that gives me a good place to start, but as always ( always is where I’m concerned ) theres another question, how do I find which wires go to the heater, can i test it from just removing the top?or is it a sides off job. Also is there a level of resistance it should read.

Regards

John

[Author]

Posts