[johnnyhoz]

Re: AEG 72620 Sticks on 8minutes

I don’t have the info to get into the diagnostics where could I get it from?

[johnnyhoz]

Re: AEG 72620 Sticks on 8minutes

Yes george the time starts at whatever the program duration is, it counts down does the wash and the stops every time on 8 minutes
John

[johnnyhoz]

Re: Bosch washer WFO2865UK/01

Thanks Tim, contacted the customer again who said they tried it on another wash and it went through normally

[johnnyhoz]

Re: Candy Washer GO282/2-80 Door interlock ?

Cheers Tony

[johnnyhoz]

Re: Candy Washer GO282/2-80 Door interlock ?

Thanks Bob

[johnnyhoz]

Re: ISE 10 1606W DISPLAY GOES BLANK

To report back on this fault, replacing the board behind the facia did the trick. Ran it over several days hoping to find the leak that may have caused the fault in the first place but never found it.

John

[johnnyhoz]

Re: Hotpoint CTD00 Dryer won’t keep running

Thanks Loopey will order one asap

[johnnyhoz]

Re: Bosch Tumble Dryer WTL6103GB/01

Thanks Martin

[johnnyhoz]

Re: Hoover Dryer VHV380

Thanks for the reply Martin, just the start LED flashes continuously

[johnnyhoz]

Re: ISE 10 1606W DISPLAY GOES BLANK

So I’ll replace the ntc and take it from there, to help my customer and allow me to search for this water leak I’m going to uplift the machine and loan her an old’n

John

[johnnyhoz]

Re: ISE 10 1606W DISPLAY GOES BLANK

Hi K

In your PM you said did I reset the board ? is this the same as The Total reset described in the Service manual? if so it won’t let me do a reset it has no effect holding the S1 start/stop button and then turnig on the power.

John

[johnnyhoz]

Re: ISE 10 1606W DISPLAY GOES BLANK

Went back to the above washer and located the ntc, there was signs of water around, dryed it and then tested it with my meter it measured 7.5kohms the service manual says 6.1-3.8kohms will this mean a replaced or will it improve when dries out more?
Will the faulty ntc cause no motor action and stop me doing a total reset and getting into the test programme?
On every progam it fills and once filled immeadiatley drains then either resets or the display goes blank with NMA. tried spin only, still NMA.
Tested heater element again for earth fault and continuity all ok, also motor has no earth faults.
During testing was looking for water leak although there are signs of water nothing would show up for me.
Apart from the distance problem 40mile round trip the customer is getting irrate as she didn’t expect a problem this early in 10 year warranty but thats the way it goes.
Any more advice please?

John

[johnnyhoz]

Re: ISE 10 1606W DISPLAY GOES BLANK

Thanks K

[johnnyhoz]

Re: ISE 10 1606W DISPLAY GOES BLANK

If it is a wet or damp thermistor is it just a matter od drying it and finding the source of the the leak? what reading should I get to test if it’s faulty?

[johnnyhoz]

Re: ISE 10 1606W DISPLAY GOES BLANK

Thanks for the advice, this is my first call on the 10 and also it’s a 40 mile round trip and I’ve already been there once so it would be good to take as much information as possible this time.

John

[Author]

Posts