Forum Replies Created
-
Posts
-
I have just noticed when looking online that there will be a Number stamped On top of the casing . I have managed to get the machine going meantime so when the cycle is finished I’ll have a look.
got it on now, stat should be okay as it popped when in use back in March!! bought air fryer that night whilst waiting on a new element and have never bothered to get it fixed!! 😮
SUCCESS! thanks for your assistance it was priceless, ill order up a thermostat light now.
My girl SHALL have Christmas Dinner!!so there’s a wire comes from the back of the stat housing this went into the lamp then another wire came out the lamp into a tab on the next controller. all i done was removed the lamp and went straight from the stat to the tab on the next controller. this would make it blow?
Really thought I’d cracked it but still blowing. Can’t see where else to look. Thanks for all your tips.
so bypassed the indicator light with its short and still it trips out! , time to call the repair man, really though id nailed it. gutted.
I look forward to trying this later.
will it work without a bulb in? As I could try without to see if thats the cause.further information I think when it first happened the oven was in use.
electrofix wrote: ok look at one thing. if its got an oven lamp take out the lamp and look for burn marks on the lamp. had a few flash over
if ok then try something
disconnect both wires from the element and fan motor.
do you mean 4 connections in total to remove and insulate ? 2 from each.The light still works, will I still check this? And with both the fan motor and the element disconnected , did you mean if it still pops it CANT be either ? (Not sure if it was a typo?)
need to go out but will try later this afternoon.
thanks for the advice.444449200 Is the model number it is correct in the reply to the post up above. It’s a belling Enfield E552. I have gone round every bit this morning with my meter and cant find anything untoward , all circuits seem to meter through as they should. I’ve left a message for the repair guy so hopefully get it sorted for Christmas!
