Forum Replies Created
-
Posts
-
Re: AEG BENDIX ZANUSSI ETC SEALED TUBS
Used to work for them, very disapointing!
What if something gets stuck in drum such as babies clothes.
Can’t do the repair machine scrap!Re: List of washers with sealed/welded tubs
Just to add to the madness, any engineers had a coin, screw, nail or bra wire stuck in the tub. Even had a small childs trouser leg, can’t remove due to tub being sealed. Machine scrap, manufacturer quoting miss use. Nice one!
Re: CCJ, where do I go now?
hi
Have you tried the cash protection agency?
£40:00 & they will get your money, even if they have to take them to court, they bounce the costs back to the debter!
Re: Whirlpool Dishwasher ADG450
Hi
check the bottom of the sump as these get greased up badly.
often a kettle of hot water can help?
Sometimes can be main PCB ouch if it is.
I have had a couple where I have had to change the owi device.
this is basically a pressure switch in the sump.
Also just check the harness inside the door very prone to broken/ cracked wiring!
Re: newbie belling db3 heat issue,,
Hi
Is it the fan (circular element) you replaced?
If so suspect selector switch faulty, although unusual on these!
Re: AEG LAV50500 programmer errors
yes door lock most obvious, can sometimes be the water distributor.
Lyamens terms means the top of the dispener. These can be electronically controlled causing sticking & nothing on some cycles!
Re: Stoves / Belling Energy Reg
Hi
No need to write off.
There is a kit which changes this to a normal ego or diamond H regulator.
You may need some knowledge of how to wire this, but I have changed them several times no problems.
Often if you order via masterpart/ connect it comes with wiring info anyway.
Hope this helps?
Cheers
DavidRe: Hotpoint CTD80 More Water Leaks
Hi
The pumps tend to work when tested short time.
They often fail half way through drying time, causing water build up & then leaks.
The pump comes as a kit which would suggest common fault!
Cheers
Re: zanussi zu7115
To be honest manufacturer direct only bet, often nor as expensive as you may think!
Re: Zanussi ZSF6066 dishwasher dead.
Hi
Pcb everytime on this one.
Cheapest believe it or not usually is going online direct to manufacturer for parts.
Cheers
David
Ex Zanussi engineerRe: candy oven not working at all
Hi
This is either the Thermal cut out faulty or maybe the timer itself.
cheers
Re: Beko DRCS68W condenser dry belt + modif info going on Mo
Hi
Generally its the front felt bearing which causes this.
They split & jam the drum, which then makes the belt skid & snap.
Change front felt & belt every time.
Be very careful the belt is a b*st!rd to fit!!!
Re: Belling 900G(R )oven thermostat 46THC8/J5
Hi
If ypu can give me model number & serial etc I can search elsewhere, not all systems allow for manufacturer I.E diamond H part Numbers.Cheers
David
