[Richard Jones]

Solved!

Tested and it started tripping on the top+bottom only.

After a bit of poking i noticed the replaced thermostat wire (which is about 5x longer than needed) had started to unwind. Bingo – it had been in and around the spade connector to the bottom element and was touching it. Quick cable tie and testing later, problem sorted 🙂

[Richard Jones]

Cheers, will have a poke around this afternoon

[Richard Jones]

This is what i get n the neff website

https://www.neff-home.com/uk/supportdetail/product/U17M42N0GB/01#/Tabs=section-spareparts/

[Richard Jones]

It’s a U17M24.0GB

Just to add, I replaced the bottom oven thermostat just before Xmas, so I have had it out and the back off before, wondering if it’s something in doing that? Was fine up until about 3-4 weeks ago.

[Richard Jones]

Hi Dave

It is 4 spades in 2 pairs

grey + red/white stripe

and then black + red on the lower one

edit: is it a case of piggybacking both cables onto a single spade?

double edit: I’m an idiot – they are already piggybacked

[Author]

Posts