Forum Replies Created
-
Posts
-
Re: Bosch – water from matrix top vent
It has only recently started doing this, so unless the water pressure has changed… I feel it is a control issue. It only happens at some points in the programme, for example the last fill at the end of test programme P1. The inlet valve energises 3-4 times in 1 sec intervals (approx), beyond the float/diaphragm control switching. The behaviour seems consistant and no errors are reported.
Re: Bosch – water from matrix top vent
Now thoroughly clean; no change to the overspill behaviour though.
Re: Bosch – water from matrix top vent
It’s certainly discoloured and difficult to see. Despite my best efforts to clean it out, it could still be clogged. I’ll give it another go.
Re: Bosch SGS65L22GB/07
I fitted a new inlet valve and it’s made no difference. I don’t beleive the outlet valve is faulty. But in any case, at the start of a rinse cycle, the inlet valve is energised for 2 to 3 seconds only and is not energised again for the rest of the rinse cycle.
Any further suggestions?
Thanks.
Re: Bosch SGS65L22GB/07
Bosch confirmed it doesn’t need configuring. In program mode it indicates mode C5, please can you confirm whether this is correct? I’ve run the customer service test program and it completes with no errors.
“Running the ‘quick wash’ programme, it fills, washes, pumps out but then fails to fill for the rinse cycle”
Actually, this isn’t quite accurate. Running either Quick Wash or Auto Delicate programs, the tub fills and washing starts (the water softener cycle runs during this time). After the first wash cycle, the tub pumps out, pauses, circulation pump runs and then a fill starts. The water is shut off before the tub has filled properly, the circulation pump is churning/sucking air (rotors don’t spin). I would have expected the tub to fill to the normal level (which is why I’d assumed control/power module), but perhaps at this point, the fill is reduced/timed only? Back to your comment about slow fill – see next.
“Pressure hasn’t changed at about 1.2 bar”
This isn’t true either. I thought it was connected to our fully pumped system. In fact it’s connected to mains at +3bar. So if the inlet valve is not opening properly…
Change the inlet valve?
