Forum Replies Created
-
Posts
-
Re: Creda Concept Solarplus grill alternates on/off continuo
John, Any chance you could advise me how to remove the ceramic top ?. I have a similar problem and can’t figure out how to get into the back of the control panel without wrecking the top !
Re: Hotpoint CTD 00P Condenser Dryer
Well it seems holding ones breath does actually help so thanks for the response mate. I only broke one tab taking it apart and guess what ! the problem was that the rubber band which poses as an impeller on the pump was broken. I cannot believe that this machine depends on a rubber band for continued operation and a rubber band that cannot be purchased separately either! It must cost around 10 p to produce one of these and yet I am expected to spend £24.00 on purchasing a new pump now. Actually, if you have a hot glue gun and a steady hand( holding the breath helps here too) then it can in fact be repaired. Not sure how long it will run for but its working fine now !!!.
Re: Creda Concept Solarspeed Grill problems
Thanks for the input guys. I have been away so have been unable to answer your posts. Still have the same problem, I have looked for a cutout switch on the grill door and cant find one or the plate you mention Dave can anyone tell me how to get into the back of the panel which holds the control knobs ?, I find exploded diagrams useful for accessing the inside of a machine and right now I don’t have a clue as to how to get into this one where I need to. An electrical circuit diagram would be useful as I would be able to see if there was a thermal cutout somewhere that needs re-setting/ replacing but dont know where to look or how to access the panel. Any advice would help. Thanks
