[Salmotrutta]

Re: Washer Dryer WDM120 leaking on Dry

😀 For completeness I can report that the fault of leaking when drying rather than when washing, is down to a split duct pipe which runs from the double cold water solenoid to the condenser unit. Only during the dry cycle water is sprayed into the condenser via this pipe to cool down and condense water from the returning hot air from the drum. This condensate is then returned to the pump via the drum for ejection. I guess that this water spray also removes fibres from the hot air and so enables the condenser to remain fluff free. So it was during this water spraying that the duct pipe leaked and put water on the floor.

[Salmotrutta]

Re: Washer Dryer WDM120 leaking on Dry

Thanks for the feedback. Where is the condenser unit and how is it cleaned of fluff? The drain at the bottom front of the machine is clear.

[Salmotrutta]

Re: WDM120 Washer Dryer – no spin

Hi,

Thanks for the feedback. The problem proved to be the module which may have been damaged by excessive sparking at the motor brushes under load and tripping out the supply. Replacement of the module plus new brushes solved the problem. It was a confusing one to solve because the module wasn’t completely disabled and only the spin cycles seem to have stopped. 😀

[Author]

Posts