Forum Replies Created
-
AuthorPosts
-
seagull
ParticipantRe: Hotpoint Bearings
philfish wrote:Brings an interesting question up, how old is the average engineer now? Somehow i do not believe there is many below the age of 35-40 and i heard somewhere that the average age is low to mid 50’s a bit worrying for the trade.
Philyep..53 here, in the game since the 1980’s
the appliances are getting bigger, we’re getting older.
My back is a mess 🙁seagull
ParticipantRe: computer running slow
i’m 52…computers scare me 🙁
seagull
ParticipantRe: British Gas
kwatt wrote:
seagull wrote:
when i left hoover 8 years ago, BG had 500 white goods engineers. not sure how many we got now, close to 700 i would have thought, but that is a guessI’m sure Gordon said little over 400 at the meeting.
K.yeah i asked today and 400 sounds about right.
only said around 700 cos when i joined, there was probably 25 engineers covering kent and sussex. now theres about double that number so (wrongly) assumed other areas had recruited as the south east hadseagull
ParticipantRe: British Gas
i work for british gas, i can verify i have NEVER earned anywhere CLOSE to 34k.
basic is 24k…you get bonuses….but not 10k worth.
when i left hoover 8 years ago, BG had 500 white goods engineers. not sure how many we got now, close to 700 i would have thought, but that is a guessseagull
ParticipantRe: a quiet few days
same in brighton, thought it was just us?
seagull
ParticipantRe: What’s the most stupid things customers say?
customer….. it makes this kind of DER DER DER GRUMPH GRUMPH GDRRR GDRRRR noise
me…. how did it go again?
customer……DER DER DER GRUMPH GRUMPH GDRRR GDRRRR
seagull
ParticipantRe: What’s the most stupid things customers say?
some classics posted here.
i’ll chip in with ‘its noisy, my husband thinks its the BUSHES’seagull
ParticipantRe: never been so quiet
busy in brighton 🙂
seagull
ParticipantRe: hoover nextra hnl 662 80
stevie w1 wrote:starts a spin cycle then stops about one min. starts as if it is going to a full spin then stops door lock still on setting is 15 on front of machine does not seem to drain
open circuit drain pump most likely
-
AuthorPosts
