simon169

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • in reply to: AEG Ceramic Hob – Fault #304826
    simon169
    Participant

    Re: AEG Ceramic Hob – Fault

    Thanks for the reply I have stripped it down and found the component I think is most likely the cause and I can’t find the part number from it any where on the internet the energy regulators I have looked at don’t look similar either.

    Anyway I have bought a new hob now but I have re-assembled the old one and it now appears to be working 😕 didn’t change anything just cleaned the inside and rebuilt it. Suspect it will pack in again at some point so now I have a spare hob, may sell it if the AEG keeps working for a few months.

    in reply to: KENWOOD KDW12SS Dishwasher #136610
    simon169
    Participant

    Not quite dead yet 🙂

    Well its not the end for my kenwood just yet. I don’t think it was responsible for tripping my electrics it seems to be willing to fight another day, best start saving for a new one though its days are numbered.

    Now I just need to find what did trip me electric twice 😕

    in reply to: KENWOOD KDW12SS Dishwasher #136608
    simon169
    Participant

    Re: KENWOOD KDW12SS Dishwasher

    Ive had this dishwasher for a few years and its finally given up I think. keeps tripping the electrics need to test this to confirm though. Can’t be bothered fixing overcoming problems on it again.

    yes all the wheels and fittings inside did break within a few weeks
    yes it does leak from bottom of door
    yes it does fail if you use anything other than finish classic tablets
    yes the fan in the door does rattle at the end of the cycle
    yes the rubber seal does come loose and drop off (i stuck it back with special clue several times)
    yes it is a very poor quality washer

    But with careful use it has lasted me for a few years.

    So I’m looking for a new machine what to go for ???

    Fully integrated required didn’t want to spend more than £400 but will go up if needed.

    Was looking at Bosch but there seem to be a lot of questions on the forums about Bosch units are they troublesome ?

    in reply to: AEG Grill & Oven element has blown up #248119
    simon169
    Participant

    Re: AEG Grill & Oven element has blown up

    Hi

    My aeg competence has done the same thing sparks flew and electric trip now just outer grill working.

    just want to check all I need is a new grill element found the part already on the site just want to make sure there are no fuses etc that could be causing this first.

    Thanks

    Simon

    PS. I cant seem to find the bulb for this oven on the site am I missing something ?

    in reply to: AEG Oven turning itself off #131616
    simon169
    Participant

    Re: AEG Oven turning itself off

    I have the same problem with my oven which is a B3101-1-m will it require the same part to repair ???

    thx

Viewing 5 posts - 1 through 5 (of 5 total)