smart

Forum Replies Created

Viewing 5 posts - 16 through 20 (of 20 total)
1 2
  • Author
    Posts
  • February 14, 2008 at 3:44 pm in reply to: Hotpoint WMA 30P ser no.82174792 #243222
    smart
    Participant

    Re: Hotpoint WMA 30P ser no.82174792

    I AGREE WITH ROBBRA. HAVE HAD A FEW WHERE WIRES HAVE RUBBED AGAINST THE CONCRETE AND BLOWN THE INTERLOCK AND SOME TRACKS ON THE P.C.B WHICH WAS EASILY REPAIRED WITH A LINK WIRE

    February 14, 2008 at 3:40 pm in reply to: Bosch WFE2021 prog fault #243262
    smart
    Participant

    Re: Bosch WFE2021 prog fault

    NOT TOO SURE. BUT HAVE HAD ONE GO TO 1 MIN BEFORE DURING A DRY CYCLE. THINK THIS IS TO TELL YOU ITS DETECTED A FAULT. IN THE CASE I HAD IT WAS AN NTC FAULTY. BUT AGREE WITH MARTIN SOUNDS LIKE A MOTOR FAULT

    February 13, 2008 at 9:09 pm in reply to: miele g679sc program lights flashing #243076
    smart
    Participant

    Re: miele g679sc program lights flashing

    DON’T KNOW HOW TO ENTER SERVICE MODE, COULD ONLY GET INTO WATER HARDNESS LEVEL. TRIED COMBINATIONS OF BUTTONS ASWELL. FLOAT AND FLOAT SWITCH OK. I’M PUZZLED

    February 13, 2008 at 10:12 am in reply to: miele g679sc program lights flashing #243073
    smart
    Participant

    Re: miele g679sc program lights flashing

    HAVE REPLACED FOR A NEW AS HAVE TRIED TO REPAIR ON PREVIOUS APPLIANCES AND FOUND IT ONLY WORKED FRO A WEEK. CONNECTIONS OK ON MODULE. APPLIANCE DOESN’T EVEN START. SWITCHES ON OK BUT SOON AS YOU TRY TO SELECT A PROGRAM THATS WHEN THE LIGHTS START TO FLASH. DONT EVEN GET ENOUGH TIME TO CLOSE THE DOOR.

    February 12, 2008 at 4:12 pm in reply to: Ignis D/w no heat #243058
    smart
    Participant

    Re: Ignis D/w no heat

    had one recently. thought pcb but wrong. turned out to be ntc. cheaper option as well

  • Author
    Posts
Viewing 5 posts - 16 through 20 (of 20 total)
1 2