[spencer123]

Re: whirlpool adp4608

HI i took it out and put power to wash motor it seems to be turning but not sure if at full capacity,is it possible it might not be running to the full speed

[spencer123]

Re: beko wm 5100w washing machine

thanks martin filter was clogged,

[spencer123]

Re: indesit idv65

cheers thanks for reply,

[spencer123]

Re: LG Tromm 12270BD washing machine

HI all problem was the hall sensor that fixes to the stator purchased from ukwhitegoods spares.thanks

[spencer123]

Re: LG Tromm 12270BD washing machine

Hi i have tried resetting as on LG website,you can hear it power up tries to turn moves slightly when you put it on a cycle EG 30 mins quick it fills trys to turn after 2 mins beeps and LE flashes on display anyone any ideas many thanks 🙁

[spencer123]

Re: zanussi zwf 1231w pcb

HI Seamy how can you tell or find out thanks

[spencer123]

Re: zanussi zwf 1231w error code 32

HI ALL have checked the pressure switch the heaters good,when machine is put in cycle it runs the whole way through till it gets to spin cycle,If you skip through programe to rinses it just circulates the water through the jetstream,If you skip it to spin and drain it wont go any further,

[spencer123]

Re: zanussi zwf 1231w error code 32

HI Martin how do you check prssure switch,Do you take it off and blow down inlet and put meter on terminals to see if you get a ohms reading thanks,

[spencer123]

Re: zanussi td 4113 tumble dryer

what do you mean closed circuit?iam getting a reading of about 1.6ohms on each then it drops down is this correct.

[spencer123]

Re: candy GOFS272 WASHING MACHINE

found the problem the fly wheel is worn the splines are worn
as wheel is plastic bad design i think,

[Author]

Posts