Forum Replies Created
-
Posts
-
Re: hotpoint wd72
Hi yes the flexible tape like with copper strips inside.There is a black connector at the end which connects to pcb 14 pins.it dropped off when I was taking front panel off machine to clear pressure switch hose. a number of terminals got pulled out off plastic connector so I resoldered them ,connected it back up display says select programme but it wont select
Re: beko 5100w
HI all still no further on with machine fitted different pressure switch
still the same takes water in washes for about 10 mins then takes in more water and keeps filling.any ideas would it be a pcb problem.Re: beko 5100w
HI martin,i checked hose seems ok no pin holes,the inlet where hose goes into drum seems clear,when you say check pressure chamber what do you check for and how,thanks
Re: zanussi zwd 1471s washer dryer
Ok martin will try.Will have to get a meter to test thanks for your help
Re: zanussi zwd 1471s washer dryer
HI Martin i couldnt get my hands on a insulation tester,but when i opened up top off machine the heater is disconnected
Re: zanussi zwd 1471s washer dryer
Hi Martin how do you test it for a earth leak can you use a multimeter cheers,
Re: zanuss 1472s washer dryer
Hi the one one this machine is all white plastic,do you think this is the problem iadom .should this be spinning fast .when you spin by hand its not hard to spin but when belt is put on it definetly does not spin as fast as the drive pulley,
Re: LG F1256QD
HI thanks for the great post very interesting,if its the ntc thats not working were is it situated and is it expensive to fix,
