Forum Replies Created
-
Posts
-
Re: Samsung RS21 drain hole
thanks, can you point me to the correct part, might as well change the evap cover because i’ve had it off 3 times to clear from fan.
no fault codes when i press the two buttons.
Ta
Steve
Re: Bosch Flood protection activated.
Sorted it now, thanks everybody for their help.
After all this messing, the hose and the pressure valve were not really that bad…..anyway, clean as a whistle now.
The inlet valve looks OK, no drips but I think I have found the source of the problem. A small leak from the hose connection, this drips onto the outside case where a nice hole leads it into the machine…….
I don’t know if this is intentional but damm clever that it can detect a fault that is nothing to do with the machine. It’s now restored my faith in Bosch.
Once again, thanks very much for the advice, wifes now happy again.
Just need to order my new shiny buttons and were good as new. 😀
Steve
Re: Bosch Flood protection activated.
Penguin45, you have me confused now….
Which part lifts out for cleaning, there are two parts with microswitches on them, the top part (263097 regulator water level) and the bottom assembly (480748 Pressure chamber) ?
I can’t see how either of these remove without taking the water tank off which is full of water at the moment.
Is the hose I need to clean 298556 and how do you remove these, pull, twist etc. Does the metal plate at the front / bottom of the machine need removing to get at the hose ?
Sorry for the questions but i’d rather just leave it than risk damaging something.
Cheers
Steve
Re: Bosch Flood protection activated.
Thanks for the advice, only the button broke, the switch is still OK.
Looks like i’ll have to dismantle the front panel to refit the switch ?
as for the blockages the one in the pressure chamber is the one to clean along with the hose from pressure chamber to the sump. the one at the top left is not really needed
When you say clean the pressure chamber, how do I get inside it, do I have to remove the whole water/drain tank ? Is the pressure chamber the 2 part chamber directly below the float switch ?
Just out of interest, what is the buildup at the top left of the tank, it’s right at the top, above where the drain outlet connects ? Does this have anything to do with my sons costantly putting plates full of phillidelia in the thing 😕 ?
Had it running continuously now for 6 hours, no water appeared in the botton so weeping sounds spot on, i’ll take a close look at the inlet valve.
Can I buy parts via this site ?
Thanks again.
