stevelup

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • in reply to: Bosch SGE09A15 service manual? #407638
    stevelup
    Participant

    Re: Bosch SGE09A15 service manual?

    Cheers.

    Found a superb document on Scribd

    119 pages long and describes how every single assembly in the unit works – including all the diagnostics. It covers dozens (hundreds I guess) of models as they all seem to be basically the same! It is American but 95{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of it is relevant to European machines.

    I believe I have fixed my problem. The water fill assembly was full of slime which meant the overflow float was triggering before the diaphragm.

    It’s run ten cycles on the test program now without any errors.

    stevelup
    Participant

    Re: Neff K3990 Fridge/Freezer – Beeping and incorrect operat

    Hi

    It’s been doing it again for two days solid now, so I’d like to bump this thread and beg for assistance!

    Fault as described above.

    Thanks,

    Steve

    stevelup
    Participant

    Re: Neff K3990 Fridge/Freezer – Beeping and incorrect operat

    All back to normal this morning… I’ll post if it does it again.

    in reply to: Bosch Display Module #319452
    stevelup
    Participant

    Re: Bosch Display Module

    Thanks for your help. I’ll give them a call.

    I suspect I will end up scrapping the oven as £250 is a lot to spend on an eight year old unit.

    All caused because a lamp blew and the manufacturer was too cheap to add a 10 pence fuse to the design…

    in reply to: Bosch Display Module #319450
    stevelup
    Participant

    Re: Bosch Display Module

    That’s the problem – in this case, they don’t sell the board, only the complete module. If I could just buy the board, I’d be happier.

    The failed component is specific to this oven so it won’t be found at RS or Farnell. I didn’t expect to be able to buy that – was merely moaning!

    The question is, is there any cheaper way of getting the module other than spending half the original purchase cost of the oven?

Viewing 5 posts - 1 through 5 (of 5 total)