[Suds]

Re: Smeg DWF 66 Dishwasher – Is it me?

Thanks Penguin45,

I have studied this further and it does appear that it happens at the same point in the program, every time. (45 minutes from the end) It sounds like a relay tripping, NOT an electrical short or arcing.

This makes me think that it is the dispenser solenoid but would this cause the display to go blank?

Also, where can I get the part number and subsequently a replacement?

Thanks for your patience and help with this.

Ralph.

[Suds]

Re: Smeg DWF66 Recirculation pump question

Oh Right, thanks for that, Penguin, I did not think of that. New seal and pack with silicon grease next then, but that can wait till tomorrow, got to do the wasing up first!!

Regards
Ralph 🙂

[Suds]

Re: Smeg DWF66 Recirculation pump question

Thanks Dave, Now I know I can split the – water sensor? – from the motor/pump I was off. the impeller unscrews from the induction motor armature shaft. Spliting the motor, I could drift out the damaged bearing and guess what – I had a spare one (22/8mm) in the workshop – not bad for a woodwork shop!

Here’s the old one:

Regards,
Ralph.

[Author]

Posts