[sylvester]

Re: Whirpool AWO 5763, poor rinsing?

Thanks for the reply, filter is clear, hasn’t been the best at rinsing since new, just seems to be getting worse though. The last time the bearings were replaced, there wasn’t much soap residue lying on the bottom of the drum.

[sylvester]

Re: Whirlpool AFB6640 Freezer Alarm

Thread a few months old, where did you get the omron relay?

[sylvester]

Re: Hoover V2000 replacement motor

Hooverman,

the part number you quoted seems to be the same, and I didn’t need to cut the rubber mount. Any chance you could confirm the motor part number?

Its got a stablemate now..miele TT5000 cat and dog 😀

[sylvester]

Re: Hoover V2000 replacement motor

GIAS didn’t seem helpful.

The problems not with the rubber its the actual motor casing (see photo) that is causing the problem.

Spoke with shop and they are as confused as everbody on the forum, anyway I removed about 4mm by 10mm of plastic from the protruding web and the motor fits ok.

Motor so much quieter than the old one(s) 😆

[sylvester]

Re: Hoover V2000 replacement motor

Had a quick look at the new grey cover and it has a moulding similar to the photo, the difference is the size, possibly 3 or 4mm smaller, I’ll speak to GIAS but I think the solution is to cut the required amount off the main casing moulding.

This hoover has won a reprieve due to the fact it can lift dog hair from carpets, its bagless and it doesn’t choke with hair, but….the catch is useless and it falls over, heavy too.

Unfortunately you can’t trial a vacuum cleaner unless its an expensive kirby and another make I can’t remember.

[sylvester]

Re: Hoover V2000 replacement motor

I’ve got the parts, Ametek motor, motor cover, agitator assy, drive belt, motor mountings small & Large, high temp sleeve & Amp tags. Horrible black spindly agitator.

Its the hoover main body that’s the problem, the supplied cover is ok

Shop half day and I live many miles away 😥

[sylvester]

Re: Hoover V2000 replacement motor

Thanks for the reply,

hoover vortex V2000 001, ser no 37651056 0003 2683.

Supplied kit motor number, on black plastic housing..054200947, on impellar cover E 063200117 Ametek Italia 04315011

On the box on a yellow slip, box was open when collected, B16-K20 order code 5031683208266….HVR97921…..159

Plenty of info, hope its what you need

[sylvester]

Re: Hoover V2000 replacement motor

Note how the grey moulding is preventing the motor fitting into the mount. Modify by removing some of the moulding ❓ No mention of this in the instructions. 😥

Is this the connector for the live? :zap:

[/img]

A picture can tell a thousand words 😆

[Author]

Posts