tennants1

Forum Replies Created

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • in reply to: Electrolux Ewn16781w won’t start #478157
    tennants1
    Participant

    I’ve took the drain pump out & Connected a lead -runs fine & hoses are clear

    in reply to: Electrolux Ewn16781w won’t start #478156
    tennants1
    Participant

    On the drain programme it runs to 1 minute but won’t end but sounds like the pump is running .
    Took the drain off & blew down it & it sounds clear.

    in reply to: Hotpoint Aquarius wf000 not spinning #323361
    tennants1
    Participant

    Re: Hotpoint Aquarius wf000 not spinning

    Sorry for being so vague, but thanks for reply.
    It does drain ok and the rest of the programmes are fine but when comes to spinning it will not reach full speed,it just does a few turns each direction and stops.
    Are you referring to the main motor bushes?
    I presume if its the module it’s not economically viable as its over 5 yrs old.
    Thanks again.

    in reply to: Whirlpool g2p not washing upper shelf #207033
    tennants1
    Participant

    Re: Whirlpool g2p not washing upper shelf

    Thanks for the reply,
    As you recommended I looked at the circ pump and it is perfect ,not in the condition in your photo Yet!

    I took the “black grid” out and gave it a rinse as it was out,but after running there was some drips from the bottom of the machine so have stopped it and switched the water off.

    I knew I should have put proper jubilee clips on instead of those dodgy “withdrawal method” jobs.

    Am still not impressed with the performance of this machine and dont want to waste much more money on it.

    What would you buy for £300 ,good deal on Smeg D1612CA £279(£150 off)?
    Fed up of wet floors!
    Cheers
    Richard

    in reply to: Whirlpool g2p not washing upper shelf #207031
    tennants1
    Participant

    Re: Whirlpool g2p not washing upper shelf

    When I rebuilt the the dishwasher I am getting continous beeps,then when opening the door the program start button is flashing four times along with the rinse button light on.
    Does anybody know what this means?
    Thanks

    in reply to: Samsung RS21NCSV Run Out of Ideas ! #191121
    tennants1
    Participant

    Re: Samsung RS21NCSV Run Out of Ideas !

    Thanks, It was just the drain heater i fitted so that makes sense.
    Where is best place to buy evap from and any idea of cost.
    Part No DA96-00013H

    in reply to: Samsung RS21NCSV Run Out of Ideas ! #191119
    tennants1
    Participant

    Re: Samsung RS21NCSV Run Out of Ideas !

    Thanks for the reply but it was a new heater I have fitted this week so would expect the resistance to be ok.

Viewing 7 posts - 1 through 7 (of 7 total)