Tocano

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: Hotpoint Aquarius Soap Tray Leakage #136874
    Tocano
    Participant

    Re: Hotpoint Aquarius Soap Tray Leakage

    Thanks for the advise, I will check that also.

    in reply to: Hotpoint Aquarius Soap Tray Leakage #136871
    Tocano
    Participant

    Re: Hotpoint Aquarius Soap Tray Leakage

    iadom wrote:Also very high water pressures can cause the occasional dribble from the drawer, more so if you have a combi boiler, make sure that the whole of the drawer and the surround is clean and completely free of soap deposits. it can set like rock and prevent the drawer closing correctly. If your pressure is very high, try turning the pressure down a little using the two taps usually fitted behind the machine or under the sink.

    I have been having the same trouble recently. could it be due to my combi being serviced and the water pressure now higher. I have closed the 2 input taps slightly and this seems to have cured the problem.

    in reply to: Hotpoint WD63 No Power #218180
    Tocano
    Participant

    Re: Hotpoint WD63 No Power

    Penguin45 wrote:On/off switch or door interlock would be my favourites.

    Power off if investigating.

    Regards,
    Penguin45.

    Thanks for the response.

    I have changed the door interlock but still same.

    Have removed the ON/OFF switch and tested with a multimeter.
    Pins 4 & 6 close (ie short circuit) when switch is in the ON position but pins 3 & 5 remain open circuit in both ON and OFF positions. Could you confirm that this indicates a faulty switch.

    Thanks

    in reply to: fault on hotpoint wd51 washer/dryer #202278
    Tocano
    Participant

    Re: fault on hotpoint wd51 washer/dryer

    modey wrote:ok cheers, i’ll try that.

    Just wondered if you had tried that yet as I have same problem with WD63.

Viewing 4 posts - 1 through 4 (of 4 total)