Forum Replies Created
-
Posts
-
Re: Whirlpool AWM1400 – Whole unit moves during fast spin
Hiya,
Many thanks for coming back, Just wanted to give you an update and advise that this issue is technically resolved.
1 – I checked the filter and found it to be full of fluff, odd as I only cleaned it out very recently. My wife advised she’d washed the dogs blanket, which would account for the fluff.
2 – The pump has started to cavitate.
The fluff clearance has made a difference, the machine doesn’t move during the high speed spin cycle now, which is good.
I will be replacing the drain pump and the dampers, as they are pretty shot and the drum sits quite low down, even with a moderate load.
Once again, thanks. This has turned out on more than one occasion, to be a very useful forum!!
James
Re: Hotpoint SDW60 – Overfilling and only 2 weeks old
iadom wrote:Its 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} Indesit, anything is possible, a long way from the best quality on the market sadly. 😥
Having had a read of some of the other Indesit/Hotpoint posts you have responded to, I am beginning to get that feeling. Thank goodness I opted for the three year warranty!!. I thought the hotpoint was a step up from the abysmal Candy affair I had previously, which lost the ability to heat water after a year and had a failed pressure sensor after 9 months.
Wish I had just pushed the boat out a bit further and opted for a Bosch!!
Re: Bosch – No drainage of water
Hello,
Just spent a few minutes clearing the impeller, whatever was blocking it soon cleared after a quick mop up of the area.
I ran the unit through a test and am pleased to report that it is draining correctly once more.
Many thanks for your assistance :).
James
