[walnut]

Re: Zanussi Fan oven motor

Ordered a MT219 from Kitchen economy at 10.60 + vat.
does anybody know of a cheaper supplier?

Also looking for WMA10P interlocks,
Electrolux 2400W fan elements, the oven is model EOB5600W.
The oven element has no neck with 8inch diameter ( large fan blade so you cannot fit a different element, I think).
If anybody knows of a different element, pref a 3 turn element that will fit
I would be very grateful to find out.

[walnut]

Re: Corgi registration.

Been reading the threads about ‘corgi’ for the past thew weeks, learnt a lot but I couldn’t find the answers to the above questions, your right it is a minefield.

I come from an electronics background so diagnostics is right up my street.

I think I’ll ring up Corgi and ask them how your supposed to become qualified if work for yourself.

[walnut]

Re: Schriber built-in double oven hinges

Sorry for the delay, here are some pictures of the hinge.

http://www.villagephotos.com/pubbrowse. … id=1527239

regards

[walnut]

Re: Service manuals and wiring diagrams

Hi,
the product code is 34000146.
thanks for the help.

[walnut]

Re: Hotpoint WD420P Washer Dryer

Spent many an hour trying to suss this problem out in the past.
most of the time it was the pump.
On the dryer mode the pump is working more often. this would cause a tired pump to stall, the condensing water then fills up into the bottom of the drum wetting the clothes.

[walnut]

Re: Creda 37747 Condenser dryer

Decided to fit a 120c manual reset toc from RS
cost 3.50.
Thanks for the advice.

[walnut]

Re: Creda 37747 Condenser dryer

Thanks for the quick reply.
Still need to know if the two rear toc’s are both one shots to protect the dryer or 1 is a protector and the other temp control.

[walnut]

Re: Hotpoint WMA31P motor

The tip about the plug can go fit in both directions seemed to be the key.
Fortunatly the modual doesn’t seem to be damaged and the washer is now working again.
Thank you all very much for your assistance with this problem.

[Author]

Posts