Forum Replies Created
-
Posts
-
Re: Indesit Wd12x Noise??
Ok,
1. Where can I get the bearing kit from (part no, price etc)
2. Is there a fitting guide anywhere so I can bodge it myself?Thx
Re: Indesit Wd12x Noise??
Looks like its scrap! so where’s the best place to find a good price on an integrated machine as Im selling the house and dont want to put a £500 machine in for somone to enjoy!
p.s NOT Indesit
Re: Indesit Wd12x Noise??
Ok, Update. Just had the back off it (power off of course) and if I spin the drum fast by hand I get the noise. AND, there is play in the drum so I think the bearings are going!
Its an integrated machine so I would prob have to either repair or replace with the same type I guess.
Re: Indesit Wd12x Noise??
Hi, Nope the concrete looks intact. Had a closer listen and it gets louder the faster it goes, it sould like its between the drum and somthing?
Re: Whirlpool G2P DW1 bleeping when Im trying to watch the F
Its a bit far to come from Wales but Ill name a sausage after you how’s that?
p.s Its working great !!
Re: Whirlpool G2P DW1 bleeping when Im trying to watch the F
Penguin45, gegsy
Thx a lot guy’s, it’s been running now for 20 mins and no bleeps and lots of water going in and out. Loooks like I can get the bbq ready for tomorrow night now and watch the match without any nagging!!
Brilliant, Thx
😆 😆 😆
MikeRe: Whirlpool G2P DW1 bleeping when Im trying to watch the F
Ok, the number is 8542 347 15810. I have the bottom plate off the machine (power is off) and I have taken the black grid off, it is as you say completley blocked with grease etc so I am cleaning it now. Also i noticed by the inlet is a white plastic tank that looks like it has brown sponge inside is this right? I aint going to bed till it’s done so it could be a long night!!
Re: Whirlpool G2P DW1 bleeping when Im trying to watch the F
No, thats the strange part, its still out and the hose is straight, I even took the hose off and checked it and it’s fine.
Re: Whirlpool G2P DW1 bleeping when Im trying to watch the F
Thx Penguin45, Footy’s finished now so I have taken the machine out and straightened the hoses. Ran the washer again on a rinse and hey presto i could hear it working and it seemed fine. BUT, then i tried it again and this time I could hear no water going in and then it started bleeping again. Is there a way I can check the inlet path?
