Forum Replies Created
-
Posts
-
Re: Tips, Tricks & Shortcuts
Hi Martin good idea in fact I think I have a plastic filling knife somewhere.
ThanksRe: Tips, Tricks & Shortcuts
I recently have opened a few washing machine doors with broken handles by cutting as large a rectangular piece as possible from a plastic milk carton, fold long ways and then double it over so you have about 4 ply/ layers. Then insert it in between door and front panel to push door pecker back. You might have to add a few more layers if the spring holding the pecker locked is stronger.
Or if anyone knows of a flexible strong plastic let me know.
Good luck!!
A1alRe: Wiring diagram for solid hot plate
Ps. Do you know is there a section on here with wiring diagrams listed?
Re: Wiring diagram for solid hot plate
Thanks Dave, I was thinking of following the wiring for one of the normal solid plates on the cooker. I used to have a diagram that showed the wiring for the 5 or 6 stages for the hot plate as you rotated the switch.
The cooker is. Belling farmhouse 900 with no data badge.
Thanks for your replyAl
Re: hotpoint dryer tdc 32
check the motor capacitor, if the ohms value is down any more than 5{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} then motor will stall under heavy loads and cause heater t/stats to blow, had a few dryers do this.
Re: cooker hood question
Hi, possibly it is because all electrical parts are double insulated similar to a lot of small appliances like hair driers and TVs etc…..
Re: Beko WM 74155 LW
Came across one of these, it was the door interlock that was faulty on the machine I looked at. Replaced door interlock and small PCB.
Re: Hotpoint Aqualtis AQ113D697E
Try resetting the machine, the procedure is listed in this forum near the top, F05 is pressure switch stuck or blockage in sump hose or pump.
Re: Aqualtis AQ113D697E constant pumping out
What do you mean by a linear pressure switch?
The one fitted to this machine is blue in colour and has 4 wires connected to it by edge connector.Re: Aqualtis AQ113D697E constant pumping out
Hi Martin
Does a new pressure switch need to be reset as I’ve read in some posts?
AlymerRe: Aqualtis AQ113D697E constant pumping out
Sorry meant to mention that it does not show any fault codes that I can see.
ThanksRe: Whirlpool F/F S20D RSB33-A/G
Changed the Fridge electric baffle unit thats let the cold air in from the freezer, it was sticking in the open position so the temperature in the fridge was going to low and the freezer was over freezing due to the moisture getting in from the fridge side.
This seems to have sorted it.a1al
