antman08

Forum Replies Created

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • October 31, 2013 at 10:28 pm in reply to: lg washing machine #403687
    antman08
    Participant

    Re: lg washing machine

    Yes lg sent me both and I replaced both…this improved slightly drum rotating but still had grinding jamming sound with washing in….when drum stutters I can push motor to get it going again but it then stutters / grinds again… Strange fault… I thought complete new stator and rotor would fix it….cheers

    October 31, 2013 at 7:26 pm in reply to: lg washing machine #403685
    antman08
    Participant

    Re: lg washing machine

    Thanks for advice but as new motor fitted would a new hall sensor be in that…. If not will try it….cheers

    February 27, 2012 at 10:01 am in reply to: hotpoint BFI 620 #369922
    antman08
    Participant

    Re: hotpoint BFI 620

    THANKS FOR YOUR HELP..EMW ONLY REPAIR NO HEAT FAULT ON THIS DISHWASHER BOARD…THANKS

    February 27, 2012 at 8:39 am in reply to: hotpoint BFI 620 #369920
    antman08
    Participant

    Re: hotpoint BFI 620

    I SENT IT TO EMW….USUALLLY DONT HAVE ANY PROBLEMS…DO U THINK IT COULD BE BOARD FAULT…CHEERS

    May 3, 2011 at 3:26 pm in reply to: zanussi zdt 5052 dishwasher problem #350423
    antman08
    Participant

    Re: zanussi zdt 5052 dishwasher problem

    thanks will try cleaning where blue tubes go,,,havnt reversed tube but i can see easily done,,,thanks for reply..going to cust on thursday so heres hoping…

    January 5, 2011 at 9:03 pm in reply to: indesit di620 error #340241
    antman08
    Participant

    Re: indesit di620 error

    thanks for reply… hav checked heater with meter and get 25 ohms…safty stat is ok….could it be pcb fault or poss pressure switch…

    September 21, 2010 at 9:16 pm in reply to: washing m/c bosch wae24162uk/01 #330980
    antman08
    Participant

    did continuity check on heater and thermistor. wash results are poor and extended sometimes…

    May 27, 2010 at 8:40 pm in reply to: hoover vhw8540 e11 fault on rapid wash #321126
    antman08
    Participant

    thanks for help helo_75…. you were spot on…wire on stat was badly crimped
    remade connection…all fine…

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)