Forum Replies Created
-
Posts
-
I have such kind of problem on my own integrated combi uWave AEG after years of using because restriction of magnetron cooling ventilation channel by dust and tripping safety thermostats.
electrofix wrote: well no fault codes listed on the tech site
hoover dont make these and never have made dishwashers
I would check pressure switch first
dave
Candy?
I’m remember this kind of heating/water pressure control sistem on late 20 years ago…Perhaps it has drain related problem (error E3).
Beside PCB related, verify pressure level switch, heater and safety switch (41901973 part.) .
After resolving possible issue, in order to pass this stage you have to open the door, keep PROGR button pressed for 3 sec and close the door and wait…Sorry… my mistake
It has to be like you have written…I wanted to edit my post but I didn’t managed…
Furhan wrote:Pump sounds fine.
I need to manually fill and test.Is the test program for this washer dryer:
P 1 Turn the machine off
P2 Turn the machine off
P3 Turn the machine off
Switch it back to p1
Turn the machine on and switch it to drain
Press&hold start buttonI had a search through the forum and results for all of the older Indesit were there – found this on YouTube.
ThanksNo
Start pozition is 12′ clock
“power on” -> turn P1 -> “power off” -> return to 12′ clock ->
“power on” -> turn P2 -> “power off” -> return to 12′ clock ->
“power on” -> turn P3 -> “power off” -> return to 12′ clock ->
“power on” -> turn P-1 (drain) -> “Start” (isn’t neccesary to hold)
It has to be done in steps, every (instruction/step) / second…And all additional option settings (temperature, spin or drying time) on maximum positions… without laundries (empty tube).
Furhan wrote:
Reconnected the machine and now the pump comes on for a couple of minutes but it does not fill at all.How its sounds? it still have water inside on tube?
If YES: With machine disconnected: look also to Eco ball… and pressure switch chamber by filling water till door glass level and blowing some air thru pressure switch sensor tube in order to clean the chamber.
Reconnect machine and give an spin and drain program till ends
If NO: fill manual some water inside (above gasket level) and start spin and drain program till ends.Also you can start AutoTest program.
I don’t know if its helpful but here is an image…
So perhaps if you can open this, you’ll be able to repair…. I think that’s 12V motor operated…
Sorry… You have to dismantle entire dryer for this job. But if you have thin hands you might be able to change it only removing front parts in order to get inside from space between drum and right side panel thru bottom right corner…
