Forum Replies Created
-
Posts
-
jontymox wrote:
I’m wondering if anyone can confirm what the Error Code “H” relates to for the above dishwasher?
I suspect that it has sensed that it has overfilled, as far too much water is drawn.On older DEA module, it could be not sensing water inlet flow? equivalent with Error 06
Did it take water in? tap/inlet hose is blocked? inlet valve is working? does flowmeter works?twicknix wrote:
Says that you press start, nothing happens. I have a feeling that it is more likely to be either internal fuse or magnetron or relay switches on the board.
But, what’s happen with time? did he starts counting down without activating transformer? Do appear sounds of transformer?
Connect a lamp instead transformer and see if he’s lighting… If yes you have on High-voltage part problem if not than PCB(relay) or thermostat or door switches…twicknix wrote:Customer reported that no microwave action happening
Do 220V appear on transformer? Can you select other program without microwave function? Does he works?
First of all check in settings that isn’t in “DEMO” inside “Settings – Showroom programme” …set NOUnplug just for few seconds… at least 20…
On the old tech manual is written 36 for “Konfigurierungscode”… I think that will fit.Yes, do you need to configure/set the board.
The procedure has to start in the 10s from plugin into powerline.
Do not forget to set bit “ON” after setting the XX/YY number that you have on oven label… Otherwise you get back into F03 stage and you have start again thru disconnecting from power…Washdisher wrote:. All connections and wiring checked and double checked. No ‘visible’ signs of damage to other modules,
Sometimes because the main module communicate with user interface thru other modules you have to check either main module and user interface (also old dryer broken module) that they got damaged on those channels.
I mean to check at list for shortage between pads or pins of connectors of communication cables…
In your case test also fan motor…ED7
WD thermostat failure
With satellite board: Incongruence between WD heating 1 and 2 relay sensing or thermostat sensing out of limits.
Without satellite: Incongruence between heater and drying relay sensing. Manual or automatic thermostat opened, wiring , WD board defective, drying heater element.I will start with reading errors.
Afterwards I will start with checkings…
In case of last error F10 I start with:
“Non-return housing, check and clean the air vent valve”twicknix wrote: I am unable to access to exploded diagram
Advice is always greatly appreciated
Thank you
MattTry this:
https://www.miele.co.uk/category/1300032/laundry-care-spare-parts
and after point to picture related button…jontymox wrote:
I suspected the board, as power is getting to it, and confirmed that the main power connections (two grey wires) are receiving a good voltage from the suppressor to the board.However, the board arrived recently, and I fitted it today… to find the fault remains…
Regards,
jonty
Lets try again,
So I understand that even the new board is giving the same problem: “Does not light up“
From this point, you have to connect on the bench without any peripherals (one different power cable on the back of selector) and give a step rotation to selector (select any position of him apart ON/OFF).
Board should light up with an error….
I have doubt that new module has the same defect…Adrian
There could be problems also with leakage to earth from heater other with worn wiring conector on doorlock side or missalign of door hook inside door frame.
