Forum Replies Created
-
Posts
-
Re: beko 1512 taking to long
hi,have you got a copy of the instruction book, there is a fast wash and a rinse hold button on this machine but she is not sure if the button has to be pressed in or out to work, and im not either,thanks.
Re: beko 1512 taking to long
ok she timed the quick program on with any empty machine and it finished in aprox two hours so ill have another go at it ,thanks for the advice.
Re: beko 1512 taking to long
hi,she said it takes forever so ive asded her to time a fast wash do you know how long it should take? in thinking 30 to 45 mins.
Re: wiring diagram wma34
hi,is there anything wrong with setting , im not getting any messages, bluejack.,
Re: bearing tool
thanks for the advice i got them in using the old bearings on top and tapping them in with a copper mallet , but i never thought of heating the inner drum center up or putting the bearings in the freezer. but its given me some other ways of trying next time , thanks bluejack.
Re: bearing tool
hi, its a wma 11 hotpoint i fitted one set in with an home made tool but the drum vibrates badly at high speed (1200 spin )so i tryed to knock them in with a drift and hammer with obvious results , ive looked on ebay and the net but i dont know what the name for them is.
Re: hotpoint aquarius washer dryer wd46
hi, ive just had another look and you were almost spot on it wasnt the wiring it was the pipe that had been put on the wrong valve , ive swapped them around and it works fine , but the customer said she had called out a service engineer 4 times and he had not fixed the problem , i wonder how much he had charged her , but thanks to your advice she wont need him anymore and i didnt charge her anything more than a nice cup of tea-well she is 84 and lives a few doors away, thanks again, regards andy.
Re: hotpoint aquarius washer dryer wd46
sorry its a wd64- the conditioner pot will only fit one way the water goes in to the conditioner pot as normal on that stage ,there are two pipes one in to the conditioner pot and one in to the main wash and both have water going to them when the machine starts its programe.
Re: zanussi fjdr 1666w
still scratching my head on this one , there is a left over connector block that does not fit to anything but one of the pump wires goes to it , am i missing something. i doine all the checks on the information that bob sent over for me , and it should be working ok. but it aint .
Re: zanussi fjdr 1666w
it has the main board and a board at the bottom i think this one is the motor speed control its much smaller and only has one connector block,
Re: zanussi fjdr 1666w
hi, replaced the recirculation pump with a spare and then with a new one but it still is showing E85 ,and cant be reset in the diagnostic mode, so i think its the board unless anyone has any other ideas, thanks.
