[bluejack]

Re: zanussi fjdr 1666w

it fills with a little water turns for a bout a minute then starts to add more water, but then emptys and the display shows 3 is this time remaining or a fault, is not the wast pipe thats at the right hight , how do i go in to fault mode?

[bluejack]

Re: hotpoint wma62

hi ,try EMW electronics on the net they do reconditioned pcb on a exchange for your old board.

[bluejack]

Re: powder draw

whats brick acid ?

[bluejack]

Re: wma 46 not draining

thanks, you where right got the front off and there were wires hanging down all over the place and more than one where damaged, changed board and wiring harness, but seems to be a bad design none of the wires were cable tied just hanging loose , but thanks again .

[bluejack]

Re: indersit wi 101

thanks,

[bluejack]

Re: indersit wi 101

hi there are 7 flashes followed by a long pause then 7 flashes, thanks .

[bluejack]

will that be ok on plastic ?

[bluejack]

still got the samsung looks the dogs bits but ive only got to look at and it leaks,regarding the other one think ill try from underneath.

[bluejack]

hi, yes i found a small drill bit in the door seal dont know how it got there , im new to this site but i think its mutts nuts , most people i know want paying for there advice so thanks to all.

[bluejack]

ive tested the stat with a meter and its not showing anything and its not a resetable one

[bluejack]

Re: cold cycle

ive checked the element with a meter it was about 25 ohms is that about right ?

[bluejack]

Re: taking to long

hi sorry ist an indersit dg100w.

[Author]

Posts