Forum Replies Created
-
Posts
-
Re: BOSCH WFO2467GB/15 DIAGNOSTICS
Yeah , thanks Martin , wash heater is solid and it does heat ,so motor is looking suspect
Re: BOSCH WFO2467GB/15 DIAGNOSTICS
Hi Martin
On the wash cycle the appliance will not complete the cycle, it continues to wash and wash with 1 on display .
If stopped it will do a rinse or spin and complete those cycles.
Insulation has been checked and the motor is just above 10 meg , could this be an issue ? i don’t know how low it should go before it causes problems , we don’t generally do bosch so experience is a bit limited
Thanks IanRe: Indesit Moon SIXL145Kuk
Hi Jim
if you could send a manual it would help
had a feeling i had heard of this before
my email is ian@ferrerstech.co.uk
many thanks IanRe: F gas Certification
Hi
wonder if we could get away with category III but i think II is the likely requirementRe: auto w/d zwd16270w
Hi
check ntc in hose at bottom of condensor
have had a few with broken wire on plug
but need to look very closely
either that or check ntc itself and the one on the top ducting as well should be about 5k at room tempRe: BEKO 6152 W
Hi
i have the tech info for the pcb and fault finding flowcharts if you want
if you let me have an email address i’ll send it
regards IanRe: ewx14440w electrolux
hi
try the DRY heater it’s possibly got an earth fault on it
we have found that anything below 5 meg causes problems
just disconnect the heater and try again thats the most common
other than that look for earth leak on motor or wash heater
good luck
IanRe: Frigidaire FRF170FF fault code E1
Hello Bryan
we,ve changed the air temp ntc and the evaporator ntc
any ideas ??
Are there any other sensors we couldn’t find or do you have to clear fault code from memory ??
Thanks IanRe: Tecnik Spares
Hi Andy
need 2 single circuit regulators front left and rear right regs
If you can help
Thanks Ian
