[Clives]

Re: Bosch Dishwasher

Sorry, yes thank you for your reply.
I will use the Trade Technical Forum in future.

Thank You.

[Clives]

Re: Hoover washing machine 8yrs old

Check connections to motor tacho, wires brake at tacho, just check the resistance, it should be about 40 ohms i think. also check motor rotates both ways on wash.

[Clives]

Re: Zanussi Hob ZKT641H

Thanks for your reply electofix

Is the eeprom on the display panel or the power panel

I could do with the manual for this hob to help with the repair

My email address is cjones3@aol.com

Many Thanks for your help

[Clives]

Re: Zanussi ZWD1260W

It just about starts the spin, just after the distribute 55 rpm right and left it starts to ramp up to about 100 to 200 rpm then shuts off and goes to stop. (if it was the triac wouldnt it just go flat out spin)
Thaks for your help. Clive

[Clives]

Re: Hotpoint WD420 dryer problem

Have you tried checking the dryer solenoid valve or make sure water is running into condenser

[Clives]

Re: Hotpoint dryer CTD00.

Last one of these i looked at with no motor action, it was a fault on the timer but tapping the timer with a screwdriver made the motor start–with a bit of burnning smell. 😕

[Clives]

Re: samsung stuck on 7 mins

Many thanks for this information, this is the exact fault. I do gather that i need to replace the whole PCB panel ?

Thanks again 😀

[Clives]

Re: Diplomat Dishwasher

Many thanks Chris. Next time it throws up this fault code i’ll check dispenser solinoid.

[Clives]

Re: statesman washer

Went to one of these the other day. Apparentley they are made in India and are designed for the lower end market. W1011 is a basic freestanding machine. Simple and easy to work on. Check for broken wires at pump connections. Best of luck 🙂

[Clives]

Re: Whirlpool Dishwasher

Many thanks for your help, as you say thermistors read ok on meter but soon as voltage applied they can go haywire. Will change termistor. Thanks again 🙂

[Author]

Posts