Forum Replies Created
-
Posts
-
Re: Simpson Ezisensor 8kg service manual
Discovered they are made by Jin_Yang oil seal Co Korea
They dont answer any of my e-mails ?
Re: Simpson Ezisensor 8kg service manual
Thanks managed without it.
Case #2, no brg/seal ket available for ezeisensor machine, must buy complete gearbox at $300. How ridiculous, bearings are not a problem, seal presents some difficulties, someone somwehere makes them, anyone have any links
Re: Aquasmart WL70T60 diagnostic mode entry? + Balance probl
Nice to know, its just not my imagination
Re: Haier top loader xqj31b erroor code e8
Fixed several of these with various other faults. seem ok when fixed
yes they are chinese crap, but its where we are all headed for.
might as well start the learning curve nowRe: F&P Error 43 Out Of Balance – Trap for young players
not so, some do have open I have discovered also
Re: Smartdrive 051 , keeps on looping rinse cycle
this looks like error code 31.
Book says motor controller out of sequence.
refer error code 17.
Action
Turn off s/drv at wall wait 5 seconds. turn back on. Restart
If Fault persists disable auto-restart feature and retest. a new code will appear. ?
Carry out action of new fault ???Never did fix this one, just replaced motor controller. bit short on time is money thing
Re: Simpson Eziset 550 wont start 3 flashing lights
This one finally got me beat. wrote it off as uneconmic to carry on. Time is money. No prizes for this one Mr Simpson
Re: Simpson Eziset 550 wont start 3 flashing lights
UPDATE:
Fitted another cpu, also got service manual,
panel passed all selfdiagnostic inputs from the manual with flying colours.
Still wont go, just same faultRe: Simpson Eziset 550 wont start 3 flashing lights
36S550L*00 sorry didnt think this was part of the model # its a good inch or so away from the rest of the number s/n is 42070153
Re: Simpson Eziset 550 wont start 3 flashing lights
No oob problem. in fact no alarms of any kind.
I Just fitted another cpu that I ordered. This one is definitley faulty, it wont accept any programming inputs at all, and has a bad AC plug socket contact on the board that cuts in and out, so I guess this goes back too
Contact works fine on the original one
Still leaves me in same dumbfounded mess, with the original cpu. Machine sitting waiting for input of some kind, In progress light is on but no progress to anything. Spin or wash. (pressure s/w activated)
I have tested the wiring loom. test run the motors and and valves, all work ok independantly
I have noticed that I am being supplied with differing model and version numbers than originally fitted.I am being assured by the parts supplier that Once reprogrammed they should should work. Maybe Not methinks
Found cause of lights, needs lid on (magnetic switch)
Really dumbing down today
However this did not fix it.Pump runs ok on its own, checked every valve and switch and motor on it now.
result is Zilch, can only suspect I got issued a dud exchange cpuRe: F&P Active Smart E372B Fault and diagnostic info ?
Thanks, guess I needed to exercise some grey matter anyway
Re: F&P Active Smart E372B Fault and diagnostic info ?
Found the problem. bad wiring loom crimped connection in plug socket to fan, this is a factory fault that could affect just more than one unit.
makes controller think that fan is not running when it is.
Just cut it all out and make your own new connection
