Forum Replies Created
-
Posts
-
Re: Tweaking Thermostat setting screws
its a Smiths (ww563) k59-p6827, for normal frig/frzr use. not frost free
Tube is no prob to get at its on viewRe: Tweaking Thermostat setting screws
Tried new d/f timer . But I think it boils down to me fitting the wrong stat for this model. right ones are on backorder so F&P Say.
Frost free Frig/Fzr stat has longer off time, I must be able to tweak it rather than wait weeks? Months?Re: GW10US Cycle Stops at each spin step
Its a faulty control panel, just spent most of day with similar prob, only mine would stop b4 the end of the spin cycle, as well as just like it turned off. but earlier than it should
Re: Fisher and Paykel Clothes Washer – 00110010 error
Also discovered that a faulty temp thermistor causes this, maybe its missing or unplugged
Thanks, was aware of most of what you have said.
had me stumped as could not find anything obviously wrong, may have just been a connector, although i had allready reseated these a few times with no effect.When i get real desperate with somthing like this I usually short circuit all the pins by putting the pcb on a piece of tinfoil and pressing hard, hopefully disharging whatever is keeping the code on, sometimes works wonders
Thanks for that,the pcb has been on bench for a few days, put it back in, guess what its ok now, must have reset itself somehow
Gotta be grease or seal stiffness, a change of controllers and panel dint fix it. give that xtra 1/3 turn by hand away it goes, motor only seems to give one kick each way to sense posistion, and appears to rely on coasting the remainder of the way, if it dont coast freely it dont go. thats my story any way
Thankfully not, its an iwm10nz washing machine, anyway changed out the rps and now it goes, still not 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} satisfied that was the problem. time will tell
Re: FISHER & PAYKEL GW711 – TEMPERAMENTAL
Read my post abt magentic relationship and tired magents, sounds like a typical case
