[DAR01]

Kwatt, thanks for the reply,it’s possible the cooker Model may be SI-9TF-GRA-CH, i can’t find any reference to the timer for this model,do you have any reference to the lettering on the PDF you attached please?

[DAR01]

Hi Dave, shouldn’t there be a 1 in front of the Part Number you have suggested?

[DAR01]

Thanks for the reply, wasn’t sure if it was held in by 2 self tapping screws.

[DAR01]

Thanks for the info, the Circulation Pump fitted at the moment is a 1736100300, can you tell me if the 1740701500 will do as a direct replacement please as i can’t find any info anywhere on the former.
Mike

[DAR01]

Sorry should read DFN1000X

[DAR01]

Re: ISE5 fault E10

Thanks for your quick response,will check motor and inverter board.

[DAR01]

Re: ICEKING RK110C Fridge Thermostat

Thanks for your reply Don,looks like this part is no longer available as an Iceking spare.

Mike

[DAR01]

Re: Bosch D/Washer SMS40C12 Polinox Joint Leak Sealing Quest

Just an observation, with this problem iv’e found the heatpump because of the leak has water ingress,(ie causing the power to trip and the heater to fail) sometimes requiring a new pump.
Whatever the pump will probably need completely drying out.

[DAR01]

Re: Bosch D/Washer SMS40C12 Polinox Joint Leak Sealing Quest

I have used Bond IT HT30 heat resistant sealant, available from Connect Distribution (Part No 5045172034304) normally used for attaching oven door glass.
But make sure all the surfaces are completely dry, i normally seal side and rear.

Hope this helps

Mike

[DAR01]

Re: Siemans SN25M230UK/01 dishwasher not heating

Thanks for the info much appreciated.
Mike

[DAR01]

Re: BEKO WMA620W DOOR OUTER

Thanks but Part No 2821130100 only has 11 screw holes, the one i need has an extra hole near the hinge.
Mike

[DAR01]

Re: John Lewis JLWM 1203 914522514 00 Program Resets after 5

Just an update on this one incase anyone has similar problem turns out it was a dry soldered joint on one of the relays on the control module.
Mike

[DAR01]

Re: Bosch SMS63M08AU/07 with No Water

You could try changing the reed switch Part No.BSH611317,the flow sensor wheel may be turning but the reed switch could be short circuit. Sometimes giving the measuring tank a tap near the water wheel can release the reed to prove that it is the reed sc.

[DAR01]

Re: INDESIT IWME126UK Washing Machine

Thanks yes i am going to send both boards to EMW.

[DAR01]

Re: John Lewis JLWM 1203 914522514 00 Program Resets after 5

No checked for that.

[Author]

Posts