Forum Replies Created
-
Posts
-
Re: Indesit tech
hi clive, an eprom is the little micro chip that fits on to the control board. some of these chips were a push fit and so could be easily replaced(no soldering)but there was a few different eproms,and a few different boards 🙄 so you had to make sure that you had the correct eprom for the correct board 😕 i think that the new ones allready have the eprom soldered in, to avoid confusion
Re: beko dv5531 electric cooker
does’nt look like it dave. this does seem to be some sort of coating.
Re: Servis w/m door/interlock prob
hi victor, try taking the outer/inner door trim off,(just clips together)and see if door lock then engages properly. sometimes these door trimscan slip and stop door from closing properly 8)
Re: Homark Spares
hi don, havent got part no,s but try caremark 08707502435 they should be able to help
Re: Van Servicing
hi rob,as long as the garage that does the servicing is v.a.t. reg there is not any problems with warrenties etc.(so i was told by mercedes 8) )
Re: ISE reliability
hi,tim. dont forget what some of your lovely customers will leave in their pockets from time to time 😯 the odd coin rattling about will get you a call out,also the bra wires,the dirty socks and those sexy little thongs 8) are great at blocking those hoses and pumps 😉 so sell the ise with confidence,the only time it breaks,its the customers fault 😆
Re: Do I believe in ISE?
taking delivery of my third machine tomorrow,delivering it tomorrow night.thats an extra £240 inthe past 2 weeks 😀 (luvlly jubbly 😀 )
Re: zanussi rear 1/2 tub
easier than hammering on those bearings :wink:usually i change complete 1/2 tub, take old one home and change bearings there.then use that one at next job. last one i got,the bearing housing came out,so unfortunately i need a new one.
Re: zanussi rear 1/2 tub
thanks guys, just phoned customer with price and she said no thanks 😯 could’nt even interest her with an ise 😥
