Forum Replies Created
-
Posts
-
Re: AEG T65270AC dryer Error code
“The drum does get extremely hot.
Apart from the thermal fuse on the heater is there a thermostat fitted anywhere else?”
Hi,
did you check NTC sensor and relays on PCB?Re: electrolux undercounter freezer wont start
Yes.MKP and electrolytic capacitors are located on the PCB
Re: Gorenje d72325 not working right
Hi,
maybe this information can be helpful:
On condenser dryers and under certain operating conditions condensation process (humidity air) can generate water in the place between the fan and the electric heater.
Condensation is generated at a specific conditions – temperature difference between process air and the ambient temperature on the back heater cover.
After some drying cycles (water under the fan) operating fan pushing the water on the el. heater.
Consequently, there are main switc off-FI voltage protection.Greeting!
Re: AEG T65270AC dryer Error code
Hi,
E60 means:
– Compressor Hardware Failuew
– Compressor short-circuited
– Compressor “sensing” circuit faulty
– VSC Safety Alarm
– VSC motor plug not connected
– VSC Current Trip Failure
– VSC over current Failure
– VSC – motor not following
– VSC Board overheating
– VSC under voltage Failure
– VSC over voltage Failure
– VSC unknown message FailureGreeting!
Re: electrolux undercounter freezer wont start
Hi,
Primarily check mkp capacitors and then the electrolyte.
Greeting!Re: Whirlpool Integrated Thermostats
Hi,
Many times I was in a position that can not get original spare part.Problem solved so that I get any thermostat with approximate length of the capillary tube and switching on temperature from 3.5 to 4.5 degrees. Minimal switching off temperature should be from -8 to – 15 degrees.Re: candy EVO W6853D wont final spin
Hi John,
You probably do not have MEM programmer?If so start
the self diagnostic.Thereafter check if water heater leaks to earth.
If the resistance is less than 50 Mohm replace heater.Greeting!
Re: Hoover washer dyn9144 d3x – weird faults
You have to read error code by means MEM programmer and reprogramm eeprom primarily.
Greeting!
