Dragan

Forum Replies Created

Viewing 15 posts - 46 through 60 (of 64 total)
1 2 3 4 5
  • Author
    Posts
  • December 23, 2006 at 4:06 pm in reply to: Whirlpool AWG 450 D/W Error Code #198693
    Dragan
    Participant

    Re: Whirlpool AWG 450 D/W Error Code

    Hi,Fairdeal
    Do you know 12NC number?AWG 450 is top loader washer.

    Dragan

    December 21, 2006 at 8:19 am in reply to: Siemens Siwamat WXB860BY/05 #197930
    Dragan
    Participant

    Re: Siemens Siwamat WXB860BY/05

    Thank you,Simone

    December 18, 2006 at 5:35 pm in reply to: WMA38P #198180
    Dragan
    Participant

    Re: WMA38P

    Who is producer of this machine?

    Dragan

    December 17, 2006 at 3:45 pm in reply to: Indesit WIDL 126 UK #198073
    Dragan
    Participant

    Re: Indesit WIDL 126 UK

    The best way to check fukcionality of this machine is by means of tester
    Housing Seriale EVOII,Indesit order number is C00145046.

    Regards,Dragan

    December 17, 2006 at 3:37 pm in reply to: Siemens Siwamat WXB860BY/05 #197928
    Dragan
    Participant

    Re: Siemens Siwamat WXB860BY/05

    Yes,it is completely clean.

    Dragan

    December 15, 2006 at 7:10 pm in reply to: Siemens Siwamat WXB860BY/05 #197926
    Dragan
    Participant

    Re: Siemens Siwamat WXB860BY/05

    Yes,few times in sucession.
    Sorry if I make lot of mistakes in English.

    Dragan

    December 11, 2006 at 6:12 pm in reply to: Zanussi Tumble Drier Error E40 #197617
    Dragan
    Participant

    Re: Zanussi Tumble Drier Error E40

    Diagnostic routine is next:

    1.Switch ON by turning programme selector one step clockwise
    2.wait until the LEDs light and buzzer sound,then simultanously press buttons START/PAUSE and DELICATE DRYING or HUMIDITY LEVEL -it is up to model.This must be done within 5s.
    3.Hold this buttons until the LEDs begin to flash and the buzzer sonud

    Regards,Dragan

    December 9, 2006 at 4:57 pm in reply to: Miele Novotronic W149 #197422
    Dragan
    Participant

    Re: Miele Novotronic W149

    Thank you very much, Clayside.I will check it from Monday.May I send you private message if problem stay unsolved?

    Regards,Dragan

    November 24, 2005 at 6:35 pm in reply to: Dish washer Siemens SE4237/37 #155423
    Dragan
    Participant

    Re: Dish washer Siemens SE4237/37

    Sorry Martin, I have said “at the beginning”-water valve is not at the back panel,but at the end of water hose.

    November 24, 2005 at 6:31 pm in reply to: Dish washer Siemens SE4237/37 #155422
    Dragan
    Participant

    Re: Dish washer Siemens SE4237/37

    Inlet valve is located at the beginning of water pipe.I have checked
    the ohm value-it is about 2 kohms,but no voltage when machine is switched on.

    November 6, 2005 at 3:14 pm in reply to: Sharp ES-S 750 #153068
    Dragan
    Participant

    Re: Sharp ES-S 750

    It is top loader washer with fuzzy logic control,self-diagnostic but I do not know to start test program.
    For Dave:SHARP, MFG.NO.2203257
    I would like to be dragon but I am Dragan only.

    I appriciate for futher information.

    September 23, 2005 at 5:11 pm in reply to: indesit wil143s #147951
    Dragan
    Participant

    Re: indesit wil143s

    It is F12-No communication display card-LED Main card

    -Chech the efficiency of contact on card of J 11 connector
    -Check of continuity of J 11 connector-display card 5-pin connector
    -Replace main card
    -Replace display card/LED

    If You need Service Manual You should send me Your private e-mail

    Dragan

    August 30, 2005 at 11:03 am in reply to: hotpoint dwf50 dishwasher #146023
    Dragan
    Participant

    Re: hotpoint dwf50 dishwasher

    Hello,
    send me your private e-mail and you will have Service Manual !

    Dragan

    August 29, 2005 at 4:40 pm in reply to: Zanussi semi intergrated dishwasher drain problem #145556
    Dragan
    Participant

    Re: Zanussi semi intergrated dishwasher drain problem

    Maybe,I could help.Send PNC number on my account.

    Drgan

    June 25, 2005 at 9:30 am in reply to: hotpoint DWF50 fault code #139464
    Dragan
    Participant

    Re: hotpoint DWF50 fault code

    Hi,

    I have send Service Manual to You but it has returned to me.Is next address corect: ableappliance@gmail.com ?

    Dragan

  • Author
    Posts
Viewing 15 posts - 46 through 60 (of 64 total)
1 2 3 4 5