drewb

Forum Replies Created

Viewing 11 posts - 16 through 26 (of 26 total)
1 2
  • Author
    Posts
  • March 16, 2011 at 12:51 pm in reply to: Candy CMD146 Problem #347197
    drewb
    Participant

    Re: Candy CMD146 Problem

    Thanks for info.

    Drum is noise free etc when spun without belt.

    It is also very stable / quiet when on high speed rinse cycle.

    The noise is only noticable when spun slowly.

    November 2, 2009 at 9:13 am in reply to: Candy Washer Dryer – CMD 146 #300601
    drewb
    Participant

    Re: Candy Washer Dryer – CMD 146

    Belt and pulley replaced so hopefully we wont have further problems.


    Thanks

    October 27, 2009 at 9:28 pm in reply to: Candy Washer Dryer – CMD 146 #300600
    drewb
    Participant

    Re: Candy Washer Dryer – CMD 146

    Yes,

    Its a Candy Engineer.

    So I should make sure belt & pulley are replaced?


    Thanks

    October 27, 2009 at 8:04 pm in reply to: Candy Washer Dryer – CMD 146 #300598
    drewb
    Participant

    Re: Candy Washer Dryer – CMD 146

    Hi Bob,

    Can you advise what the fix is?

    The engineer is coming on Friday and I want to make sure he does more than just re-install the belt.


    Thanks

    October 27, 2009 at 5:43 pm in reply to: Candy Washer Dryer – CMD 146 #300596
    drewb
    Participant

    Re: Candy Washer Dryer – CMD 146

    Some very wet towels when the belt came off this time so possibly overloading.

    I am having difficulty to get the belt to stay on now so perhaps it has stretched.

    October 27, 2008 at 8:55 pm in reply to: Help – Candy Aquaviva 1300, leaking filter !! #265933
    drewb
    Participant

    Not quite there.

    Getting a small drip after the spinning cycle near filter. I have sealed the three hoses connected to the filter with Silicone.

    Any ideas of the cause?

    Thanks

    October 25, 2008 at 4:01 pm in reply to: Help – Candy Aquaviva 1300, leaking filter !! #265932
    drewb
    Participant

    Re: Help – Candy Aquaviva 1300, leaking filter !!

    All sorted. Replaced entire filter and no more leaks.

    Thanks for the help!

    October 21, 2008 at 11:48 am in reply to: Help – Candy Aquaviva 1300, leaking filter !! #265931
    drewb
    Participant

    Thanks for the help. Filter kit ordered.

    I am hoping it is just the screw in plug that needs replacing.

    If I need to replace the full kit, is it an easy job? I dont mind a bit of diy.

    Thanks
    Drew

    October 20, 2008 at 9:46 pm in reply to: Help – Candy Aquaviva 1300, leaking filter !! #265929
    drewb
    Participant

    Re: Help – Candy Aquaviva 1300, leaking filter !!

    Model number from door is N 37616562 0142 4087.

    To the untrained eye, it looks like something a rubber gasket would fix. I appreciate its not always as it seems.

    Thanks for the reply.

    Drew

    March 13, 2008 at 3:14 pm in reply to: Neff B1320 Oven not heating up – element faulty ? #245297
    drewb
    Participant

    Re: Neff B1320 Oven not heating up – element faulty ?

    Element replaced and oven is now functioning normally.

    Thanks for the help and advice.

    Drew

    March 9, 2008 at 8:41 am in reply to: Neff B1320 Oven not heating up – element faulty ? #245293
    drewb
    Participant

    Re: Neff B1320 Oven not heating up – element faulty ?

    Penguin45 wrote:Good pot boiler here:
    http://www.ukwhitegoods.co.uk/modules.p … ge&pid=103

    You will need a test meter to test the element for resistance if there is no obvious damage.

    Element is p/no 262180 – an email to spares@ukwhitegoods.co.uk for prices and ordering if required.

    Power off first, of course.

    Penguin45.


    What could it be if the element is not faulty?

    Thanks

  • Author
    Posts
Viewing 11 posts - 16 through 26 (of 26 total)
1 2