gegsy

Forum Replies Created

Viewing 15 posts - 5,536 through 5,550 (of 6,724 total)
  • Author
    Posts
  • in reply to: Bosch WFR 2860 long cycle times #173225
    gegsy
    Participant

    Re: Bosch WFR 2860 long cycle times

    Good point Martin, however he may put on boil wash but never check door glass heat. Like I said before they will end eventually even with heater failure.2-3 hours for boil wash is normal so would not suspect anything afoot.
    Heater elimination then we can move on.

    Greg

    in reply to: Grill won’t stay lit #173242
    gegsy
    Participant

    Re: Grill won’t stay lit

    I doubt its jet more likely the grill mesh is clogged with fat spatterings etc.
    Probably best repair would be to change grill burner assembly. This however would have to be undertaken by a Corgi engineer.

    Greg

    in reply to: Bosch WFR 2860 long cycle times #173223
    gegsy
    Participant

    Re: Bosch WFR 2860 long cycle times

    NTC is a sensor which determines the temperature of the water.

    Greg

    in reply to: Bosch WFR 2860 long cycle times #173220
    gegsy
    Participant

    Re: Bosch WFR 2860 long cycle times

    Ive had some where heater has gone and no fault has been registered.]Worth a check. NTC still could be faulty.

    Greg

    in reply to: Bosch WFR 2860 long cycle times #173214
    gegsy
    Participant

    Re: Bosch WFR 2860 long cycle times

    Hi
    Just humour me on this one.
    Just check if your waste pipe from appliance has gone too far down the physical plumbing rigid pipe, ie more than a foot down it. If so you maybe experiencing syphoning which would extend wash cycle on ALL settings though.
    You can also check the heater (access from front) approx 30 ohms, and check your filter for any blockages.
    Un plug appliance before attempting any repair please :plug:

    Greg

    in reply to: Bosch D/W Test Procedure Enr SGS5312GB #173043
    gegsy
    Participant

    Re: Bosch D/W Test Procedure Enr SGS5312GB

    Hi
    Trust me there are none.
    Only settings are to cancel and to set water hardness.

    Greg

    in reply to: Bosch KGU 34640 #173112
    gegsy
    Participant

    Re: Bosch KGU 34640

    Hi Neil
    I would imagine freezer part is choked up with ice, thus compromising air flow for efficient operation.
    I would suggest defrosting for 24hr hours and see how you go.
    If problem re occurs I would consider a problem with the frost free and as this is a complex beast check the link to engineers on my signature below.

    Greg

    in reply to: Gimme some money!!!! #172998
    gegsy
    Participant

    Re: Gimme some money!!!!

    goosegreen wrote:God I must be getting old! When i was a lad it cost £1.50 to get to see the Spurs 🙄

    Goose

    and included programme and bus fare home 😆

    Greg

    in reply to: Neff D/washer S5433XOGB/13 Recirc Motor Fitting #172922
    gegsy
    Participant

    Re: Neff D/washer S5433XOGB/13 Recirc Motor Fitting

    :rotl:

    in reply to: Bosch KGU 34640 #173110
    gegsy
    Participant

    Re: Bosch KGU 34640

    Hi Neil
    Corrrect model number please, l/h side of cabinet when you remove salad drawer.
    Given facts so far would assume PCB failure, will know more when you reply with details.

    Thanks

    Greg

    in reply to: Postal Scam – beware! #173046
    gegsy
    Participant

    Re: Postal Scam – beware!

    Do you really want to hurt me Martin or take me to the church of the poisened mind. I guess its just your Karma Chameleon making us all The Victims.

    Greg 😆

    in reply to: Bosch WFF2000 Washing Machine Motor #173049
    gegsy
    Participant

    Re: Bosch WFF2000 Washing Machine Motor

    If it has GB/ 1,11,12,14 after main model number then it has the same motor namely 141344 approx £140 +Vat.
    Use spares link on my signature below to order.
    Power off as always when undetaking any repair :plug:

    Greg

    in reply to: Postal Scam – beware! #173044
    gegsy
    Participant

    Re: Postal Scam – beware!

    Cheers Martin :tup:

    Greg

    in reply to: Neff D/washer S5433XOGB/13 Recirc Motor Fitting #172920
    gegsy
    Participant

    Re: Neff D/washer S5433XOGB/13 Recirc Motor Fitting

    I usually do same as Boro but put appliance on its back on workmate, much easier. No hassle, easy man!

    Greg

    in reply to: Bosch KGU3201GB/01 letting water out below bottom baxket #172976
    gegsy
    Participant

    Re: Bosch KGU3201GB/01 letting water out below bottom baxket

    Yes panel behind baskets. Remove round covers and you will see knibs that retain panel. They usually break 🙄 Just be as careful as you can

    Greg

Viewing 15 posts - 5,536 through 5,550 (of 6,724 total)