Forum Replies Created
-
Posts
-
This is the name on the invoice :
Zanussi Spanrol breed 22×50 -as 8mm- 1250125034
google translate:
Zanussi Tensioner wide 22×50 -shaft 8mm- 1250125034
Dave , what do you mean that there is no real heat ? Is the type I have without heat pump ? What causes then the heat ? The settings as said : are all maximum so more heat will be given .
I will check the led of the container if it goes on, I don’t think i went on, will keep an eye.
So now about the heat issue, what else can I check before i start ordering..?
I replaced the pulley, even the belt, as i was not yet broken , I just never replaced it before and it shows traces of damage.Dave , if I undertand Electorofix correctly, he said that i need to replace the drum roller, as my pulley gets damaged after one week… .I’m just not sure where to find the drum roller.
if the container is the place where the clothes are in, it’s not full with Water.
I always dry at max heat level.
Ok, so if i’m going to order, as I already ordered the belt and motor and know need to order the pump, I want to save on transportcost and maybe wait for info if I need to order other parts. I just read in my previous thread that I might replace drum rolllers, as this could be the reason why the pulley gets bad so fast. I did not yet check if there are again traces of the plastic everywhere. Will check it before I start to order.
So the drying issue will be solved if the pump is replaced?
Dear thanks for the info. I don’t seee this part in my motor or is it situated elsewhere? I only see the black pulley.
ok about the tube. The worm bearings , are they part of the pump or do I need to order them separately? I didn’t understand the latest sentence.
Ok thanks . So the waterpump needs to be replaced so the water can leave. We don’t use the draw but directly F to the drain , i read again the user manual , the tube that goes to the drain must not be to long , I never Cut the tube . Should this be a cause then I can cut it . As the drain is behind the dryer. Not even a 10 cm.
i also took some time to watch videos and started to clean : don’t know the name, see photo :
https://www.dropbox.com/s/igp7g7brd9clliz/How_to_clean_IMG_8491.JPG?dl=0
om the videos they could take it out and wash it . Mine is full with dust and don’t know how to disassemble this part , any help ?
Thanks .
what is the function of this pump ? Can it cause the issue ( not drying good )I have ?
I have seen many names of pump : heat pump , condens pump , water supply pump, I want to know if one of these is the same as the one in the link.
Stationary = drum stopped
if I understood correctly then yes this noise only to hear at the end when drying is finished . Not always .
Could you send a link to this part ?
Dear
the clothes are still not completely dry.
and when the dryer finishes, there is a noise, this time it was higher and I recored it.
see dropbox link as I’m not allowed to upload aiff files.
Google translate ?
i took the motor pulley out and put it back in but In reverse . I notitced that the one end is not the same as the other end . No I thing there will be no plastic everywhere . After test I will no if it’s fixed.
I’m from Belguim, I found it online from a Dutch (The nederlands, our neigbours) online shop:
https://www.partsnl.nl/zanussi-onderdelen/zanussi-spanrol-1250125034-wasdroger
It should be a original one, … .
So I should send them the picture?
or can it be that something else causes this ?
