Forum Replies Created
-
Posts
-
I can’t upload the picture , it’s to big.
see Dropbox link ( no Dropbox required )
https://www.dropbox.com/s/h03yt1rzl57jz6i/Airdryer_pulleypart_IMG_8292.jpg?dl=0
Finally finished assembling the tumble dryer and is working again. The repair of the print plate solved the issue ( tumble dryer dead).
.
Dear
After putting the panel back, the power button did not function anhmore.
So I took a second change and then to discover that this diffuser is just the led light thing? so see photo how it was simply put and this should be done before I but all back ..
came cleare while assembling.. 🙂
Thanks anyway for you effort. hope this can help others too.
OK thanks, so the diffuser should not be firm in the possition? I will try to put al back, hope the diffuser will not fall out of the start button.
Re: AEG strange sound not drying anymore
Dear all
after the issue was solved on 23th march 2016 , it’s back again .
we are not yet 2,5 year further, and same sound is made by the machine.
Is it normal that such a piece (see link dropbox in previous message) goes bad in 2,5 years? or is it possible another piece causes the mentioned piece to break faster? hmm
Re: BEKO product code SN 140220 – changing door direction
I almost forget,I also mentioned that the part that is used to open the door is a little bit loos.
How can I fix it?
Re: BEKO product code SN 140220 – changing door direction
product code: 7254648716
I will give the manual a try . thanks, and yes I’m form belgium
Re: Beko WMD 26145 T does not start spinning
Problem sovled, machine is back in action :-).
I replaced the carbon brushes and this helped.
Thanks for everything (this forum and the videos).
Re: Beko WMD 26145 T does not start spinning
thanks for the clear explaning video’s 🙂
I managed to test the sensor: 4,4 K ohm, when holding it in my arms, the value dropped. I tested it again: 3,8 K , holding and value dropped.
So seems ok for the heating element.
What is next to test?
Re: Beko WMD 26145 T does not start spinning
ok, heating ohm is 26,3 Ohm, so ok
the temperature senso, can I just get it out using force on that white connector? or can it break?
see image:
Re: Beko WMD 26145 T does not start spinning
I found the heating eleemnt, disconected the cables, can I check without taking the heating element completely out?
Re: Beko WMD 26145 T does not start spinning
Gived it a try to check the led lights, they don’t flash, so will have to open it to check the warming element. I hope it’s the back side I have to open to find it, as the front side is very difficult to open as I tried it.
