[Holty]

Re: Smeg eror code E4

Before i go and puchase a soap dispenser, can anyone confirm that the resistance reading i am getting across the coil in the dispenser is to high, 1147ohms. Smeg model DI 612 C. Cheers.

[Holty]

Re: Smeg DW1612C suspect control board?

Hi, have the same model and the same problem. Could you please let us know how you get on.

Regards Holty

[Holty]

Re: smeg dwi612c not finishing cycle

Hi, i have the same fault. Stops, beeps and tries to continue with the selected program light flashing. Waste water in the bottom of dishwasher.

Davelad have you replaced your dishwasher yet? i have the same model. Perhaps you may have spare parts i could buy off you?

Uncle D have you got to the bottom of your problem yet?

My hands are going seriously soft from all the washing up!!

Cheers

[Holty]

Re: Smeg eror code E4

Hi, have tried the temp sensor(used a meter and witnessed resistance change when heat applied) and have given the pcb a good/close looking at. Both seem fine.
Put it all back together and and tried it on another program. Same thing happens. Stops towards the end of cycle and beeps, tries to go again and beeps. Appears to have washed and is on a hot rinse cycle tries to progress to next stage, but is unable to. When door is opened the choosen program LED is flashing. Also waste water still present in the bottom of dishwasher.
I suspect that the flashing LED is because the program has ended early due to the door beng opened. This is not a fault code?

Regards Holty

[Holty]

Re: smeg dishwasher di 612 c e4 fault

Hi iain71
Did you get to bottom of your problem as i have the same fault ,E4. Penguin45 suggests it might be the sensor, pcb, etc. on my post.
Cheers Holty

[Author]

Posts