[jenson]

Re: Bosch wfl2067gb/14

Yes sorry it does have LEDs,the problem is you can set washer to wash an LEDs light etc and you can do that 1 wash,after tho if you try to select another program the LEDs won’t light an the machine will not work,weird thing is if you leave it off for 4-5 days and try again it will wash once more then same no led/start problem

[jenson]

Re: Neff d/w s5543x2gb/17 overfills and dead?

hi,it doesnt start off dead,you can select program and it will fill till the overfill float moves slightly,not enough to cause pump out and then the machine is dormant,no motor action,iv cleaned all the pipes and chambers on this dishwasher a month ago so all clear

[jenson]

Re: bosch wae28469gb/14 "0" in display

thanks for reply,that has done the trick!

[jenson]

Re: Bosch WTA4007GB/04 cuts out

thanks martin,3 stats on rear so didnt think one was at front,will try linking out tomorrow

[jenson]

Re: Neff d/washer S5453X1GB/50

would you expect to see damage or slight burning on these boards martin,cause iv had both out and no sign of that at all.

[jenson]

Re: Neff d/washer S5453X1GB/50

hi thanks martin,no visible damage on boards,best i price up a couple of boards then

[jenson]

Re: hotpoint fdm550p

ok cheers,but theres no sign of water in base,iv had this running with side panel off,i think the heater may have damaged the pcb as it is doing alot of strange things,think ill have to scrap it

[jenson]

Re: hotpoint fdm550p

ok after messing around with it,it has stopped pumping and started to fill,then aborts again with all wash dry an end lights flashing

[jenson]

Re: bosch wvti2840gb/04 e13 fault

ok thanks,ill try that,but did test both heaters an readings were spot on

[jenson]

Re: bosch washer,wae24363gb/05 fault f19?

ok quick update,have been to this an its been worked hard,10-15 washes a day! have found the motor carbons worn out an the element low on insulation,replaced both on the of chance it would erase fault,but it stays on the display no matter wot,sure i have reset one of these by holding start an turning dial,didnt work tho,does anybody know how to do this?

[jenson]

Re: bosch sgs46e12gb/73

just to update that impeller jug did the trick,thanx

[jenson]

Re: servis m9503

hi mike,it is the large board,have checked all contacts and their fine

[jenson]

Re: servis m9503

just to note both facia boards iv checked visably and are fine,same with the large 1 down the back which i have replaced on other machines but generally with a spin fault

[jenson]

Re: bosch sgs46e12gb/73

thanks chaps,iv already cleared the gunge,will be ordering a impeller jug to complete job

[jenson]

Re: Whirlpool,AWO/D4505 WORKS ON 1 PROG ONLY

sorry update,it will work on synthetic 40* wash fine,just the cottons 40* it wont,customer isnt bothered with control board repair,gotta be the board tho

[Author]

Posts