[jomutimer]

Re: Rob and Dented – I took readings and…

I have put two meters on the heater and I got the following readings.

From the simple continuity meter I got – no continuity.

From the proper multimeter set to 20k ohms I got an odd reading. It read 1 . That is 1, then a space, then a decimal point.

Do these readings tell us the heater is broken?

This thing has a flow through type of heater. When I look inside I see scale build up. It is only about 1mm thick, but could it have caused the heater to overheat at some point? Is there a reset switch somewhere? How do you operate it? I might as well try that first, if there is such a thing.

Hoping I will solve this. Stay with me guys!

Regards

Adrian

[jomutimer]

Re: A bit more -Rob and Dented, does this help?

[You’ll need to meter out the heater and wiring to rule these out.

DP

What reading am I expecting from the heater element? What does it mean if it is higherthan expected ? What does it mean if it is lower?

[jomutimer]

Re: Have I got two problems?

robwash wrote:this machine is too old for fault diagnosis. it may be an ntc or reed contact problem

Hi Rob,

I think you are right. There is no gap in the flashes. it just goes on and on flashing without any pauses.

If it is an ntc ( what is an ntc by the way?) or a reed contact problem what is my next step?

If it helps at all I have the Haynes Dishwasher Manual to refer to (but the index has nothing about ntcs or reeds)

Regards

Adrian

[jomutimer]

Re: Whirlpool ADG994 won’t heat and has a stammer

The flashing light just keeps flashing. It doesn’t stop so there is no particular number of flashes.

Regards

Adrian

[jomutimer]

Re: Whirlpool ADG994 won’t heat – more help please

Hi, I am not sure what to do next?

Regards

Adrian

[jomutimer]

Re: Whirlpool ADG994 won’t heat and has a stammer

Fairdeal wrote:Hi Adrian,

Normally with the whirlpool dishwashers if it does not heat then it will stop during the cycle and the programme lights should flash.Does any light flash?

[Adrian – Yes, thanks for reminding me of this. It does get stuck and the lights do flash. If I press the button for four seconds it starts again, but the problem persists.]

Also if you can give the 85…. number ?

[Adrian – I would love to. Where is it to be found?]

Regards

[jomutimer]

Re: NEFF cooker takes the house down

Hi,

Thanks for the direction to the article. I get this now.

Since my first post I have been able to discover the model number. It is NEFF ENR: 195302 078.

I will go to your parts people and see if I can get anotehr one. Many thanks for your help.

Regards

Adrian

[Author]

Posts