[juicehills]

Re: Hoover Logic 1200 A3786

Ah well, new drive belt arrived from trusty UKWHITEGOODS in double quick time and has now been fitted, silcone removed from from pressure bottle and everything reassembled 🙂

However a new problem has developed, it is taking in water but I don’t know where it is going as very little seems to get to the drum and there is only a very small amount being taken into detergent drawer and only enough to dampent the powder at the far end of the drawer. It also seems to be “humming a lot” (electrnic humming, not the smelly kind 🙂 The only thing that changed was removing the silcone, anyone have any suggestions?

I’m under pressure now as she who must be obeyed, says the washing is piling up :rolls:

Thanks

Colin

[juicehills]

Re: Hot and cold fill

Thanks for all that folks, I “get it” now 😉

[juicehills]

Re: Hot and cold fill

I take your point but if the machine attempts to take water from the hot supply at least any cold water will at least be at room temperature before it draws any hot and that is bound to be much warmer than the cold from the rising main, particularly in the winter months when outside temperature could be as low as -20 C

[juicehills]

Re: Hoover Logic 1200 A3786

I didn’t think it looked right, many thanks for your advice, it’s greatly appreciated.

thanks again

Colin

[juicehills]

Re: Hoover Logic 1200 A3786

hello again,
I’ve taken the presure bottle off and in the pipe at the bottom end there is what looks like hard white silicone sealant, it almost looks as if it should be there, is this the case?

The belt has also snapped, could this have anything to do with it?

Thanks

Colin

[juicehills]

Re: Hoover Logic 1200 A3786

It does spin if the machine is turned off and then spin selected on it’s own and switched on again?

[juicehills]

Re: Hoover Logic 1200 A3786

Hi,
many thanks for your suggestions, it’s definitely not the creaseguard, at least switch not selected.

I’ll check the pump, although it seems to empty okay. It seems to take a long time to travel from supercare (E) to spin (G) then stcks but can you tell me how to locate and check the pressure switch system.

Thanks again, greatly appreciated!

[Author]

Posts