Forum Replies Created
-
Posts
-
Re: hotpoint wma46 rinse problem
yes i am trade and currently in the process of applying for trade access.as for the fault i have i had tacho magnet come loose which i rectified and now during rinse the drum turns to quick for a short time causing water to come out the dispenser drawer,it then returns to normal rinse speed and is fine after that.
Re: hoover tv630 dryer drum bearing
i thought so,thanks for the quick reply,im guessing everything is removed via the front panel
Re: hotpoint wd420 washer dryer drying problem
dryer chamber was fairly clean but the mesh filter was clogged seems to be drying better now,on the same machine what would cause it to vibrate severely during spin cycle.i first thought it was out of balance but it does it on every load.i noticed it puckers the door seal also,ive checked the dampers they seem fine
Re: hotpoint wd420 washer dryer drying problem
thanks for prompt reply will do that tomorrow and report my findings
Re: HOTPOINT WD420 STARTS SPINNING WHILE WATER STILL IN DRUM
you was spot on,drain hose was full of all sorts cins,nails,screws and gunge.many thanks.machine drains lovely although the tub seems to have a fair bit of movement backward and forward during the spin is this natural
Re: beko wm 510s lazy motor?
i had problems with this machine not spinning after having pcb checked i decided to replace brushes even tho the old ones had 15mm left on them.this cured the no spin problem but i notice now when running a cycle the drum seems to start slow for a split second before rotating.ive checked tacho for resistance and magnet both seem ok.
Re: beko wma510s not moving through wash sequence
machine has electronic pcb.ran it through the mini 30 minute cycle,it filled,washed,drained,rinsed,drained then when it was suppose to go to spin but the drum just turned both ways at low speed until i manully ended the program.
Re: beko wma510s not moving through wash sequence
it washes then it pumps water out then drum turns but doesnt add water for rinse unless you stop machine and manually turn it to rinse.after rinse it then needs to be stopped and manually turned to spin.
Re: beko wma510s not moving through wash sequence
yes i meant brushes(typing error).i have checked heater with multimeter,checks ok.machine heats up during cycle.
Re: whirlpool awm328 interlock?
the forum is titled help and support,many people might be just starting out in the white goods service/repair field and do not yet have the knowledge of most.
i have not yet seen a forum for attitude problems but you would be a top candidate,if you cant help people with there problems then dont reply.
