[lotusray]

Re: ise wm

cheers kwatt

[lotusray]

Re: Indesit Franchise

We are lucky to have a good supervisor who actively encourages ways of increasing clearance rates. I wonder what an engineer who gets 75{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of jobs cleared would think and do if he was a franchisee? lol that wouldnt be gary wilder

[lotusray]

Re: zanussi dishwasher

whats probably happening is its registered an over fill and drain pump has continued while door is open and it wont allow it to refill now a little out of date an zan d/w now but syphon tubes were a major problem

[lotusray]

Re: Hotpoint washing machine strange motor action problem

check motor harness for chaffing specially btm weight area also mtr plug
wma range had a few harness probs causes very similar fault

[lotusray]

Re: HOTPOINT Aquarius WMA37 Putting holes in things!

an easy wat 2 see if drum is snagging is to put a pair of tights on your hand and glide over drum any burrs will snag tights

[lotusray]

Re: Help! Hotpoint WD41 Washer/Dryer instantly tripping RCD.

just a quick 1 check wiring harnes to motor /heater were it is tied 2 cabinet heading towards heater box/ motor they chaff and start with intermittent tripping as for suppressor u neeed 2 disconnect supply 2 m/c otherwise u will read a fault there even though problem lyes downstream

[lotusray]

Re: Hotpoint Aquarius WD420 door lock time

try a slower spin speed that helps reduce crease
u can afford 2 leave it in for 3 mins if u spin below 1000rpm

[lotusray]

Re: Cheapest Genuine HPT carbons?

AHHHHHHHHHHHH BUT DO U KNOW THEY ARE ORIGINAL???????????????

[lotusray]

Re: Zanussi TD520 Not Spinning – Intermittent

probably motor capacitor

[lotusray]

Re: Firenzi FIDW41 Not filling

I DONT KNOW MAKE OR MODEL BUT SOUNDS LIKE PRESSURE CHAMBER BLOKED OR PRESSURE SWITCH FAULTY
PRESSURE CHAMBER FAV ON A DISHWASHER

[lotusray]

Re: Hotpoint After Sales Service — Problems

never going 2 get sorted with the dipsticks they promote as supervisors
a certain n west area supervisor springs 2 mind personal opinion but i know loads of the lads in the area feel the same no suport from the top
only interested in volume dont want quality anymore

[lotusray]

Re: Merloni to take control of Siemens-Bosch

u got me also but u never know it might just be in the pipe line 😯

[lotusray]

Re: Servis DW24E1 “Too much water”

IT IS WORTH GETTING IT LOOKED AT AS IT IS JUST A PRESSURE CHAMBER BLOCKAGE PROBABLY

[lotusray]

Re: Ideal Standard (French) Central Heating Boiler

u can wire a frost stat to override the timer it can be a normal t/sta set low its very easy with right know how but not a job 2 experiment with a good electrician should be able to help

[lotusray]

Re: Ideal Standard (French) Central Heating Boiler

u can wire in any wall mounted timer withthe right knowledge i would guess 80 pounds ish
not a job 2 try your self

[Author]

Posts