mike1

Forum Replies Created

Viewing 15 posts - 91 through 105 (of 131 total)
1 2 3 … 6 7 8 9
  • Author
    Posts
  • September 12, 2007 at 8:13 am in reply to: rangemaster 110 #227305
    mike1
    Participant

    Re: rangemaster 110

    when i did one the back was held on with screws and the screws that held the fan on were screwed from inside the oven. they must have changed the design on this one,it sounds a right pig.

    September 11, 2007 at 3:02 pm in reply to: Tauber B600DG (built in oven) #227296
    mike1
    Participant

    Re: Tauber B600DG (built in oven)

    what is the connect part number

    September 11, 2007 at 2:57 pm in reply to: Servis M3510S Tumbles but does not spin #227289
    mike1
    Participant

    Re: Servis M3510S Tumbles but does not spin

    check for pressure switch blockage and pressure switch fault then its normally the module. emw electronics 01159652118 the best place £25.90

    September 11, 2007 at 2:47 pm in reply to: pat test #225399
    mike1
    Participant

    Re: pat test

    good point, well put.

    September 10, 2007 at 9:22 am in reply to: LUX DDO61 COOKER #227124
    mike1
    Participant

    Re: LUX DDO61 COOKER

    i fixed one using a spring toggle rawlplug from b&q.

    mike

    September 4, 2007 at 12:12 pm in reply to: homark washer #226588
    mike1
    Participant

    Re: homark washer

    just found out its a bosch. part no. 153150


    thanks

    mike

    September 3, 2007 at 2:37 pm in reply to: bloomway ltd. has anybody heard of these?. #226502
    mike1
    Participant

    Re: bloomway ltd. has anybody heard of these?.

    Bloomway Limited is a supplier of Laundry machines and other products from Hong Kong SAR.

    mike

    August 31, 2007 at 2:26 pm in reply to: hotpoint DD77 double oven #226053
    mike1
    Participant

    Re: hotpoint DD77 double oven

    i had a similar problem to this last week where there was no visible burn marks on selector,i fitted a selector switch and it worked.


    mike

    August 31, 2007 at 8:36 am in reply to: servis m7664 f/f #226134
    mike1
    Participant

    Re: servis m7664 f/f

    a vt9 will fit,but i would always fit the original because you may get called back because the fridge temp is not correct.

    mike

    August 31, 2007 at 8:25 am in reply to: hotpoint st87ex cooker fault code 09 #225681
    mike1
    Participant

    Re: hotpoint st87ex cooker fault code 09

    i went to this one tested everything i could test.switched it back on and it worked o/k.


    mike

    August 23, 2007 at 2:44 pm in reply to: White Knight WK767 Con/Dryer #225510
    mike1
    Participant

    Re: White Knight WK767 Con/Dryer

    hi john
    it is 8uf.


    mike

    September 25, 2006 at 9:31 am in reply to: jmb ice box fridge flap #189306
    mike1
    Participant

    Re: jmb ice box fridge flap

    thanks to everyone for looking but just been told no parts available for this m/c

    September 23, 2006 at 9:31 am in reply to: Hotpoint EW91 inspection cover #189408
    mike1
    Participant

    Re: Hotpoint EW91 inspection cover

    6201695 mains terminal block cover

    September 22, 2006 at 1:08 pm in reply to: CMT.010 COOKER HOOD #189109
    mike1
    Participant

    Re: CMT.010 COOKER HOOD

    a company called betta living kitchens have sold or do sell these.they say ring 0161 627 0042 aftercare dept.

    September 22, 2006 at 12:58 pm in reply to: fagor LVC-15 #189025
    mike1
    Participant

    Re: fagor LVC-15

    try anglo iberian services on 01245 320992

  • Author
    Posts
Viewing 15 posts - 91 through 105 (of 131 total)
1 2 3 … 6 7 8 9